Crankshaft Front Seal
Usage:
Remove Crankshaft Front Seal
start by:
a) remove vibration damper and pulley
1. Remove the crankshaft front seal with tooling (A).
Install Crankshaft Front Seal
1. Use tooling (A) to install the crankshaft front seal as follows:
2. Put clean SAE 30 oil on the lip of seal and the crankshaft. Put a thin layer of 7F2770 rubber cement on the outside diameter of the seal. Put the seal on the crankshaft with lip of seal toward rear of engine.
3. Install the locator assembly (1) and two retaining screws (2).
4. Put the seal installer ring (3) on the locator assembly.
5. Install the pusher plate (4) and nut. Tighten the nut until pusher plate makes full contact against the locator assembly. Remove tooling (A).
end by:
a) install vibration damper and pulley
Caterpillar Information System:
1693 DIESEL TRUCK ENGINE Pulley And Vibration Damper
1693 DIESEL TRUCK ENGINE Turbocharger
1693 DIESEL TRUCK ENGINE Variable Timing Unit
1693 DIESEL TRUCK ENGINE Accessory Drive
1693 DIESEL TRUCK ENGINE Accessory Drive, Turbocharger
1693 DIESEL TRUCK ENGINE Fuel Priming Pump
1693 DIESEL TRUCK ENGINE Fuel Transfer Pump
1693 DIESEL TRUCK ENGINE Fuel Transfer Pump, Fuel Priming Pump
1693 DIESEL TRUCK ENGINE Fuel Injection Pump Housing
1693 DIESEL TRUCK ENGINE Governor
1693 DIESEL TRUCK ENGINE Fuel Injection Pump Housing And Governor
1693 DIESEL TRUCK ENGINE Fuel Ratio Control
1693 DIESEL TRUCK ENGINE Front Cover
1693 DIESEL TRUCK ENGINE Exhaust Manifold
1693 DIESEL TRUCK ENGINE Glow Plugs
1693 DIESEL TRUCK ENGINE Oil Pan
1693 DIESEL TRUCK ENGINE Oil Pump
1693 DIESEL TRUCK ENGINE Camshafts
1693 DIESEL TRUCK ENGINE Camshaft Bearings
1693 DIESEL TRUCK ENGINE Valve Lifters
1693 DIESEL TRUCK ENGINE Fuel Injection Valves
1693 DIESEL TRUCK ENGINE Precombustion Chambers
1693 DIESEL TRUCK ENGINE Cylinder Head And Spacer Plate
1693 DIESEL TRUCK ENGINE Valves