Electronic Control Module - Remove and Install
Start By:
- Remove crankcase breather. Refer to Disassembly and Assembly, Crankcase Breather - Remove and Install
- Disconnect harness assembly (1).
Show/hide table
Illustration 2 g06319691 - Remove bolts (2).
Show/hide table
Illustration 3 g06319694 - Remove electronic control module (3).
Show/hide table
Illustration 1 | g06319688 |
- Position electronic control module (3).
Show/hide table
Illustration 5 g06319691 - Install bolts (2).
Show/hide table
Illustration 6 g06319688 - Connect harness assembly (1). Tighten the bolt for harness assembly to a torque of
6 ± 1 N·m (53 ± 9 lb in) .
Show/hide table
Illustration 4 | g06319694 |
Caterpillar Information System:
G3500H Generator Set Engine Restriction of Air Inlet and Exhaust
C18 Generator set and C18 Marine Engines Electric Starting Motor - Remove and Install
303.5E2 CR, 304E2 CR, 305E2 CR and 305.5E2 CR Mini Hydraulic Excavators Prepare the Machine for Maintenance
C18 Generator set and C18 Marine Engines Coolant Temperature Sensor - Remove and Install
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Product Description
320D3 and 323D3 Excavators Machine System Specifications Final Drive
C18 Generator set and C18 Marine Engines Fuel Pressure Sensor - Remove and Install
320D3 Hydraulic Excavator Engine Supplements Exhaust Elbow - Remove and Install
C18 Generator set and C18 Marine Engines Engine Oil Filter Base - Install - Engine Mounted Oil Filtered Base
C175 Tier 4 Final Engines for Caterpillar Built Machines Fuel and Auxiliary Water Pump Drive - Remove and Install
320 D3 Hydraulic Excavators Engine Disassembly and Assembly Crankcase Breather - Remove and Install
PM820, PM822, and PM825 Cold Planer Prepare the Machine for Maintenance
320 D3 Hydraulic Excavators Engine Disassembly and Assembly Crankshaft Rear Seal - Remove and Install
C18 Generator set and C18 Marine Engines Vibration Damper and Pulley - Remove and Install
784C and 785C Off-Highway Truck/Tractors Machine Storage
A New Procedure for Installing a Radiator Hose Support Is Now Used on Certain 320 GC, 320 and 323 Excavators {1380, 5057} A New Procedure for Installing a Radiator Hose Support Is Now Used on Certain 320 GC, 320 and 323 Excavators {1380, 5057}
Software Update is Now Used on Certain 3500 Engines {1920} Software Update is Now Used on Certain 3500 Engines {1920}
Documentation Required for C175 Machine Engines that Experience Unexpected Engine Shutdowns {1000, 7418, 7760} Documentation Required for C175 Machine Engines that Experience Unexpected Engine Shutdowns {1000, 7418, 7760}
3500C IMO III Engines Sensor Signal (Analog, Active) - Test
Aftercoolers May be Missing the Internal Baffle on Certain 3500 Engines {1063, 1063} Aftercoolers May be Missing the Internal Baffle on Certain 3500 Engines {1063, 1063}
G3500H Generator Set Engine Measuring Inlet Manifold Temperature
3500C IMO III Engines Sensor Signal (Analog, Passive) - Test
C18 Generator set and C18 Marine Engines Vibration Damper Guard - Remove and Install
Well Stimulation Pumps Glossary