Breather (Transmission) - Clean
Show/hide table
| |
| Illustration 1 | g06162542 |
|
Location of breather on the CX38-P892 straight through transmission (1) Breather | |
Show/hide table
| |
| Illustration 2 | g06162547 |
|
Location of breather on CX38-P892 with integral PTO drive option (1) Breather | |
Breather (1) may be remote mounted with a flexible hose to improve performance of the breather. Mounting of the breather (1) should be approximately 2 feet above the transmission. The flexible hose must have a continuous downward slope from the breather (1) to the transmission case.
Note: Inspect the breather within 3 to 4 days. If air conditions are dirty, then inspect the breather daily.
- Remove the breather.
Note: For a standard breather, perform Step 2. Replace the optional 258-2829 Breather for the integral pump drive, as required. Replace the optional breather every 1500 service hours or 1 year.
- Wash the breather in a clean, nonflammable solvent. Allow the breather cap to air dry.
- Install the breather.
Caterpillar Information System:
C9.3B Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
CX38-P892 Well Servicing Transmission Plate Locations and Film Locations
2 Wire and 4 Wire Ethernet Repair Procedure on All Cat® Products {1408} 2 Wire and 4 Wire Ethernet Repair Procedure on All Cat® Products {1408}
C175 Generator Sets Engine Oil and Filter - Change
New Injector Wiring Harnesses Are Now Used on Certain C15 and C18 Engines {1290, 1408} New Injector Wiring Harnesses Are Now Used on Certain C15 and C18 Engines {1290, 1408}
CX38-P892 Well Servicing Transmission Specifications
C175 Tier 4 Final Engines for Off-Highway Trucks DEF Pressure Is Low
CX38-P892 Well Servicing Transmission Safety Messages
C9.3B Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
G3516 Petroleum Engines Cylinder Head - Install
C9.3B Engines for Caterpillar Built Machines Air Compressor - Remove and Install
C9.3B Engines for Caterpillar Built Machines Alternator - Remove and Install
CX38-P892 Well Servicing Transmission Oil Filter (Transmission) - Replace
New Turbocharger Shaft Seal is Used on Certain C175-16 Locomotive Engine {1052, 1053} New Turbocharger Shaft Seal is Used on Certain C175-16 Locomotive Engine {1052, 1053}
CX38-P892 Well Servicing Transmission Transmission Oil - Change
CX38-P892 Well Servicing Transmission Transmission Oil Level - Check
CX38-P892 Well Servicing Transmission Transmission Oil Sample - Obtain
XQP500 Generator Sets Fuel System Secondary Filter - Replace
XQP500 Generator Sets Fuel System Primary Filter (Water Separator) Element - Replace
Improved Radiator Fan Shaft Assembly Procedure Implemented in Production of C175 and 3500 Generator Sets {1353, 1356} Improved Radiator Fan Shaft Assembly Procedure Implemented in Production of C175 and 3500 Generator Sets {1353, 1356}
CX38-P892 Well Servicing Transmission Maintenance Interval Schedule
323F SA and 323F LN Excavator and 323F LN MHPU Machine Systems Specifications Pilot Lines
C7.1 Marine Propulsion Engine Plate Locations and Film Locations
C175 Tier 4 Final Engines for Off-Highway Trucks NOx Conversion Is Low