The Engine Control Module (ECM) detects the following conditions:
- The C15 engine coolant temperature is greater than
110 °C (230 °F) for more than 20 seconds. - The C13 engine coolant temperature is greater than
111° C (232° F) for more than 5 seconds. - The engine has been running for at least 30 seconds.
System Response:
"DIAG" will be displayed next to the status for "Engine Coolant Temperature" on the Caterpillar Electronic Technician (ET). The check engine lamp and the warning lamp will illuminate.
Note: If a high coolant temperature lamp is installed, the high coolant temperature lamp will turn on instead of the warning lamp.
Customer passwords are required to clear this diagnostic code.
Possible Performance Effect:
The C15 engine will be derated by 25 percent for each
The C13 engine will be derated by 25 percent for each
A 100 percent derate means that the ECM will use a default torque map and vehicle speed will be limited to
Note: If the "Engine Monitoring" parameter is programmed to "Shutdown", the engine will be shut down once this code has been active for 25 seconds.
Note: If the "Engine Monitoring" parameter is programmed to "Warning", the engine power is not affected.
Troubleshooting:
Test Step 1. Check the Cooling System
Refer to Testing and Adjusting, "Cooling System - Check".
Results:
- OK - STOP