Engine Trunnion - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 323-1146 | Lifting Gp | 1 |
B | - | Guide Bolts
M16 - 2 by 8 inch |
2 |
Start By:
- Remove the vibration damper.
- Use Tooling (A) and a suitable lifting device in order to support the weight at the front of engine (1). The weight of engine (1) is approximately
12115 kg (26710 lb) .Show/hide tableIllustration 2 g02029019 Show/hide tableIllustration 3 g02029052 - Remove two of bolts (2) that are marked with an X. Install Tooling (B). Remove the remaining bolts (2).
Show/hide table
Illustration 4 g02029057 Show/hide tableIllustration 5 g02029214 - Remove bolts (3). Attach a suitable lifting device onto trunnion (4). The weight of trunnion (4) is approximately
64 kg (140 lb) . - Remove trunnion (4).
Show/hide table
Illustration 1 | g02028968 |
- Install trunnion (4) in the reverse order of removal.
- Tighten bolts (3) to a torque of
570 ± 80 N·m (420 ± 59 lb ft) .
- Tighten bolts (3) to a torque of
Caterpillar Information System:
G3612 and G3616 Engines Air Inlet Choke - Remove and Install
C9.3 Marine Auxiliary and Generator Set Engine Electronic Service Tools
C8.7 and C12.9 Marine Engines Electrical Power Supply - Test
C9.3 Marine Auxiliary and Generator Set Engine Welding Precaution
C9.3 Marine Auxiliary and Generator Set Engine General Information
3516C Marine Engines Rocker Shaft and Push Rod - Remove and Install
794 AC Off-Highway Truck Power Train Coupler Adapter and Mounting - Remove and Install
G3612 and G3616 Engines Actuator (Hydrax) - Remove and Install
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Coolant Sample (Level 2) - Obtain
G3512 EPA Emergency and Non-Emergency Standby Generator Sets Coolant Sample (Level 1) - Obtain
3516C Marine Engines Gear Group (Rear) - Remove and Install
G3612 and G3616 Engines Air Valve - Remove and Install
C8.7 and C12.9 Marine Engines Sensor Signal (Analog, Passive) - Test
C9.3 Marine Auxiliary and Generator Set Engine System Overview
C18 Generator Set Safety Messages
C7.1 Engines Valve Position - Test
C9.3 Marine Engines Air Starting Motor
G3500H 60Hz Generator Sets Product Description
G3612 and G3616 Engines Air Inlet Choke - Disassemble
C9.3 Marine Engines Fuel Injector
C7.1 Marine Generator Set Fluid Recommendations
3516C Marine Engines Crankshaft Main Bearings - Remove and Install
C2.2 Engines for Caterpillar Built Machines Crankcase Breather - Remove and Install
C7.1 Engines Service Tool Features