Coolant Level - Check
Show/hide table
为了接近这个保养位置可能需要登上机器。 有关安全的详细资料,请参考本操作和保养手册, "上、下设备"专题。 |
配备目测液位计的发动机
Show/hide table
图 1 | g00750429 |
(1) 加注口盖 (2) 目测表 |
如果发动机配备了目测液位计,观察目测液位计中冷却液的位置。 在正常工作温度下,正确的冷却液液位是在目测液位计的上半部。 如果冷却液液位过低,添加正确的冷却剂混合液。
没有配备目测液位计的发动机
Show/hide table
加压的系统: 热的冷却液能造成严重的烫伤。 在发动机停机,等待冷却系统部件冷却下来后再打开冷却系统加注口盖。 缓慢松开冷却系统加注口盖,以释放掉所有压力。 |
发动机停机并冷却后检查冷却液液位。 冷却系统加注口盖冷却到可以徒手触摸时,检查冷却液液位。
慢慢拆下冷却系统加注口盖,以释放掉压力。 将冷却液液位保持在距加注管底部以下 13 mm (0.5 in) 范围内。
添加冷却液
注: 有关应使用的正确的冷却液混合液,请参阅本操作和保养手册, "加注容量和建议"(保养部分)。
- 停止发动机。 让发动机冷却。
- 慢慢拆下冷却系统加注口盖,以释放掉压力。 将正确的冷却剂混合液注入冷却液加注管。
- 清洗冷却系统加注口盖。 检查冷却系统加注口盖密封垫的状况。 如果冷却系统加注口盖密封垫损坏,请用新件更换旧的冷却系统加注口盖。 安装冷却系统加注口盖。
Show/hide table
图 2 | g00103639 |
密封垫 |
- 起动发动机。 检查冷却系统有无泄漏。
Caterpillar Information System:
G3600 A4 Engines Coolant (NGEC) - Change
C15 and C18 Engines for Caterpillar Built Machines Programmable Parameters
C13 and C15 Generator Sets Generator Start-up Checklist
2013/11/04 New Boost Pressure Sensor Location Is Used for Certain 3512 Petroleum Engines {1408, 1439, 1917}
C13 and C15 Generator Sets Battery Disconnect Switch - If Equipped
CX31 and CX31 HT On-Highway Transmissions Reference Material
C15 and C18 Engines for Caterpillar Built Machines ECM - Replace
795F AC and 795F AC XQ Off-Highway Trucks Hood Tilt Assist Spring - Lubricate
CX31 and CX31 HT On-Highway Transmissions Capacities (Refill)
349F and 352F Excavators Machine System Specifications Track Carrier Roller
G3306B Gas Engines Alternator Mounting
188-3922 Broken Exhaust Bolt and Stud Removal Group for 3114, 3116, 3126, 3126B, 3176, 3176B, C-10, and C12 Engines{0374, 0599, 0701, 0702, 0703} 188-3922 Broken Exhaust Bolt and Stud Removal Group for 3114, 3116, 3126, 3126B, 3176, 3176B, C-10, and C12 Engines{0374, 0599, 0701, 0702, 0703}
2013/09/25 An Improved Fuel Transfer Pump Assembly Is Now Available for Certain C9.3 ACERT Engines {1251, 1256, 1290}
G3600 A4 Engines Coolant Level Switch - Inspect/Test
G3600 A4 Engines Coolant Sample (Level 1) - Obtain
G3600 A4 Engines Coolant Sample (Level 2) - Obtain
G3600 A4 Engines Coolant Temperature Regulator - Replace
Quick Start Wiring Guide for Dynamic Gas Blending Well Service Engines{1000, 1408, 1900, 1901, 7610, 7620} Quick Start Wiring Guide for Dynamic Gas Blending Well Service Engines{1000, 1408, 1900, 1901, 7610, 7620}
G3600 A4 Engines Crankcase Blowby - Test/Record
G3600 A4 Engines Cylinder Pressure - Test/Record
G3600 A4 Engines Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
G3600 A4 Engines Engine Air Precleaner - Check/Clean
G3600 A4 Engines Engine Mounts - Inspect
G3600 A4 Engines Engine Valve Lash - Check