Start By:
- Remove the front drive housing. Refer to Disassembly and Assembly, "Front Drive Housing - Remove and Install" or Disassembly and Assembly, "Drive Housing (Front) - Remove and Install".
- Remove the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove".
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove cover (1) from the front of the cylinder block.
- Remove plunger assembly (2) and spring (3) from the front of the cylinder block.
Show/hide table
Illustration 2 g00912966 Show/hide tablePersonal injury can result from parts and/or covers under spring pressure.
Spring force will be released when covers are removed.
Be prepared to hold spring loaded covers as the bolts are loosened.
- Remove the idler gear and the shaft. Remove cover (4) on the rear of the cylinder block.
Show/hide table
Illustration 3 g00912969 - Remove plunger assembly (5) and spring (6) from the rear of the cylinder block.
Illustration 1 | g00912963 |
Personal injury can result from parts and/or covers under spring pressure. Spring force will be released when covers are removed. Be prepared to hold spring loaded covers as the bolts are loosened. |
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Place clean engine oil on spring (6) and plunger assembly (5).
- Install spring (6) and plunger assembly (5).
Show/hide table
Illustration 5 g00912966 Show/hide tableImproper assembly of parts that are spring loaded can cause bodily injury.
To prevent possible injury, follow the established assembly procedure and wear protective equipment.
- Install cover (4) on the rear of the cylinder block. Install the idler gear and the shaft.
Show/hide table
Illustration 6 g00912963 Show/hide tableImproper assembly of parts that are spring loaded can cause bodily injury.
To prevent possible injury, follow the established assembly procedure and wear protective equipment.
- Place clean engine oil on spring (3) and plunger assembly (2).
- Install spring (3) and plunger assembly (2) on the front of the cylinder block.
- Install cover (1) on the front of the cylinder block.
Illustration 4 | g00912969 |
End By:
- Install the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Install".
- Install the front drive housing. Refer to Disassembly and Assembly, "Front Drive Housing - Remove and Install" or Disassembly and Assembly, "Drive Housing (Front) - Remove and Install".