Initial Startup Procedure
注: 本程序只应由持有 Caterpillar 合格证书的维修技师来进行。 本程序应在系统已被锚固到位，所有线路已被正确连接之后才能进行。
Show/hide table
| 注意 |
|---|
初始化系统的启动前，必须完成以下步骤：系统操作，测试和调整, RENR2476, "振动传感器归零 - 标定", 系统操作，测试和调整, RENR2476, "转子位置传感器 - 调整" 和 系统操作，测试和调整, RENR2476, "转子位置传感器 - 调整" |
Show/hide table
 | |
| 图 1 | g02442956 |
触摸屏面板和手动 ups 控制装置 (1) 触摸屏 (2) USB 接口 (3) 三个位置钥匙开关 (4) EPO 按钮 (5) 喇叭静音按钮 | |
Show/hide table
 | |
| 图 2 | g02456459 |
MMU 机柜用户接口面板 (3) 三个位置钥匙开关 (4) EPO 按钮 | |
- 将各系统机柜钥匙开关转至旁路位置。 请参看图 1。
- 将各 MMU 钥匙开关开关转动到旁路位置。 请参看图 2。
- 位于系统机柜用于适当 MMU 的关闭（励磁）MMU 输出隔离开关。 请参看图 3。
- 位于系统机柜用于适当 MMU 的关闭（励磁）MMU 输入隔离开关。 请参看图 3。
Show/hide table
 | |
| 图 3 | g02454138 |
系统机柜（典型） (9) MMU 输入开关 (10) MMU 输出开关 | |
Caterpillar Information System:
2011/06/16 New Fuel Pressure Regulators Are Used on Certain C7 and C9 Engines {1715}
UPS 1000Z, UPS 1200Z, UPS500G and UPS600G Uninterruptible Power Supplys Electrical Connections
UPSB505 Uninterruptible Power Supply Cable Size Requirement
C15 Petroleum Engines Auxiliary Water Pump - Assemble
Nitrogen Pressure Test Unit FT2724 {4150, 4159, 4169, 4170, 4171, 4174, 4175, 4180} Nitrogen Pressure Test Unit FT2724 {4150, 4159, 4169, 4170, 4171, 4174, 4175, 4180}
C13, C15, and C18 Tier 4 Interim Engines Data Link - Test
2011/03/02 New Software Is Used on C175-16 Generator Sets {1901, 1920}
C15 Petroleum Engines Auxiliary Water Pump - Disassemble
793F Off-Highway Truck Machine Systems Valve (Suspension Cylinder Charging) - Remove and Install - Front Suspension Cylinder
UPS 1000Z, UPS 1200Z, UPS500G and UPS600G Uninterruptible Power Supplys Transfer Operation
C15 Petroleum Engines Auxiliary Water Pump - Install
C15 Petroleum Engines Auxiliary Water Pump - Remove
UPS 1000Z, UPS 1200Z, UPS500G and UPS600G Uninterruptible Power Supplys Pager Configuration
UPS 1000Z, UPS 1200Z, UPS500G and UPS600G Uninterruptible Power Supplys Interfaces
C15 Petroleum Engines Aftercooler - Remove
C15 Petroleum Engines Aftercooler - Install
C15 Petroleum Engines Installation Environment
UPS 1000Z, UPS 1200Z, UPS500G and UPS600G Uninterruptible Power Supplys Remote Status Panel
UPS 1000Z, UPS 1200Z, UPS500G and UPS600G Uninterruptible Power Supplys Site Preparation
UPSB505 Uninterruptible Power Supply System Earthing Arrangement
Data link J1939 on EMCP 3.2 and EMCP 3.3 Fails to Communicate on Certain Generator Sets{4490} Data link J1939 on EMCP 3.2 and EMCP 3.3 Fails to Communicate on Certain Generator Sets{4490}
UPSB505 Uninterruptible Power Supply Glossary
C15 Petroleum Engines Belts - Inspect/Replace
UPS 1000Z, UPS 1200Z, UPS500G and UPS600G Uninterruptible Power Supplys Troubleshooting