C6.6 Generator Set Caterpillar


CID 0002 FMI 02

Usage:

C6.6DE150E ECR
Conditions Which Generate This Code:

The Electronic Control Module (ECM) detects the following condition:

  • Data from the electronic unit injector for the No. 2 cylinder is out of limits.

  • Diagnostic code 0168-01 is not active.

  • Diagnostic codes 0002-05 and 0002-06 are not active.

  • No 0041 diagnostic codes are active.

  • No 0262 diagnostic codes are active.

  • Diagnostic code 0190-08 is not active.

  • No 0110 diagnostic codes are active.

System Response:

If equipped, the diagnostic lamp will flash and the derate lamp will come on. An active diagnostic code will be generated. The ECM will log the diagnostic code.

The engine will be derated while this diagnostic code is active.

Test Step 1. Perform the following diagnostic procedure: Injector Data Incorrect - Test

Results:

  • OK - STOP

Caterpillar Information System:

C6.6 Generator Set CID 0001 FMI 06
C6.6 Generator Set CID 0001 FMI 05
C6.6 Generator Set CID 0001 FMI 02
C13, C15, and C18 Tier 4 Interim Engines Inlet Air Is Restricted
C13, C15, and C18 Tier 4 Interim Engines Event Codes
C13, C15, and C18 Tier 4 Interim Engines Diagnostic Trouble Codes
3508, 3512 and 3516 Generator Set Engines Camshaft - Install
C13 and C15 Engines for Combat and Tactical Vehicles Accelerator Pedal (Throttle) Position Sensor Circuit - Test
C13 and C15 Engines for Combat and Tactical Vehicles 5 Volt Engine Pressure Sensor Supply Circuit - Test
C13-XQ350 Rental Generator Set Electronic Modular Control Panel 4 (EMCP 4)
349F and 352F Excavators Alternate Exit
CX31-P600 Petroleum Transmission Power Train Electronic Control Module (Electronic Clutch Pressure Control)
C6.6 Generator Set CID 0002 FMI 05
C175-16 PETROLEUM ENGINES Connecting Rod Bearings - Remove and Install
C6.6 Generator Set CID 0002 FMI 06
3508, 3512 and 3516 Generator Set Engines Camshaft Bearings - Remove
C6.6 Generator Set CID 0003 FMI 02
C6.6 Generator Set CID 0003 FMI 05
C6.6 Generator Set CID 0003 FMI 06
3508, 3512 and 3516 Generator Set Engines Camshaft Bearings - Install
2010/01/14 New Communication Software for the PL1000T Is Now Used on Commercial Engines {7606, 7620}
Track, Track Roller, and Track Idler Cycle Times {4159, 4169, 4170, 4171, 4180} Track, Track Roller, and Track Idler Cycle Times {4159, 4169, 4170, 4171, 4180}
C6.6 Generator Set CID 0004 FMI 02
C6.6 Generator Set CID 0004 FMI 05
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.