Inlet and Exhaust Valve Guides - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 1U-9169 | Valve Guide Driver | 1 |
B | 124-9057 | Guide Collar | 1 |
9U-6895 | Valve Guide Driver | 1 | |
C(1) | 455-0128 | Seal Installer | 1 |
375-2773 | Seal Installer | 1 |
Show/hide table
(1) | Use Seal Installer 455-0128 with Seal 163-2478. Use Seal Installer 375-2773 with Seal 361-3926. |
Start By:
- Remove the inlet valves and exhaust valves.
- Remove seals (1) from valve guides (2).
Show/hide table
Illustration 2 g03711987 - Use Tooling (A) to remove the valve guides (2) from the cylinder head assembly.
Show/hide table
Illustration 1 | g03711984 |
- Use Tooling (B) to install valve guides (2) in reverse order of removal.
- Install valve guides (1) until the protrusion is Dimension (X) above the cylinder head assembly. Dimension (X) is
20.0 ± 0.5 mm (0.79 ± 0.02 inch) . - Use Tooling (C) to install seals (1).
Show/hide tableIllustration 3 g01301738 - Install valve guides (1) until the protrusion is Dimension (X) above the cylinder head assembly. Dimension (X) is
Note: Lubricate the bores for the valve guides with clean engine oil.
Caterpillar Information System:
C13 Engine for Caterpillar Built Machines Inlet and Exhaust Valves - Remove and Install
793F and 797F Off-Highway Trucks Braking System Brakes Drag
C12 Marine Engines Heat Exchanger - Inspect/Clean
793F CMD Off-Highway Truck (Command for Hauling) Power Train Electronic Control System Backup Alarm Does Not Function
C15 and C18 Engines for Caterpillar Built Machines Cylinder Head - Remove and Install
C9.3 Tier 4 Interim Engines Engine Cranks but Does Not Start
C6.6 Industrial Engine Lifter Group
C13 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Springs - Remove and Install
C6.6 Industrial Engine Fuel Filter Base - Single Secondary Fuel Filter Base
C6.6 Industrial Engine Fuel Injection Pump
C7.1 Industrial Engine and Generator Set Indicator Lamps
C6.6 Industrial Engine Fuel Injection Lines
C13 Engine for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install - C15 Engine
C13 Engines for Caterpillar Built Machines Exhaust Cooler (NRS) - Remove and Install
C6.6 Industrial Engine Cylinder Head Valves
C6.6 Industrial Engine Main Bearing Journal
C4.4 Industrial Engine Piston and Rings
C7.1 Industrial Engine and Generator Set Sensors and Electrical Connectors
MP-15, MP-20, MP-30 and MP-40 Multi Processors Hydraulic Rotator
C13, C15, and C18 Tier 4 Interim Engines Oil Contains Coolant
C15 and C18 Industrial Engines Atmospheric Pressure Sensor - Remove and Install
C12 Marine Engines Engine Valve Lash - Inspect/Adjust
C15 and C18 Engines for Caterpillar Built Machines Crankcase Pressure Sensor - Remove and Install