An Improved Rear Pump drive Bolt Used on Certain 994K Wheel Loaders {3108} Caterpillar

An Improved Rear Pump drive Bolt Used on Certain 994K Wheel Loaders {3108}

Usage:

994K MM9

Wheel Loader: 994K (S/N: MM91-311; MRK1-204,312-324; SMX1-204)

Description Of Change: An improved rear pump drive bolt is available for the machines listed above. The improved bolt has a black colored coating and a greater fatigue life. Earlier bolts had a silver colored coating.

Adaptable To: Improved pump drive bolt is adaptable to the machines within the listed serial numbers, and is effective in production with all the machines after the listed serial numbers.

Show/hide table

Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility.

Show/hide table




Illustration 1	g06362737
Rear pump drive (1) 483-2035 Bolt

Show/hide table




Illustration 2	g06365111
(1) 483-2035 Bolt (A) Former Bolt

Show/hide table

Table 1
Part List
Item	Qty	Part	Part Name
1	2	483-2035	Bolt

Torque the bolt (1) to 100 ± 10 N·m (74 ± 7 lb ft).

If the idler shaft is removed from the pump drive, it must be frozen to −35° C (−30° F) to reduce the press fit during installation. Refer to Disassembly and Assembly procedures for Rear Pump Drive. The frozen idler shaft then must be allowed to warm within ± 8° C or ± 15° F of room temperature before installing and tightening the bolt.

Note: Do not over torque the bolt. Over torquing will lead to early failure of the bolt.

Note: If the bolt (1) is used to assist with the installation of the frozen idler shaft, then bolt (1) should be removed and scrapped after the installation. In this case, a new bolt (1) is installed and tightened to specification.