Idler Pulley
Show/hide table
![]() | |
Illustration 1 | g01256943 |
(1) Tighten the bolt for the idler pulley to the following torque. ... 50 ± 5 N·m (37 ± 4 lb ft)
Caterpillar Information System:
AccuGrade® GPS (CD700) Flashing Messages
G3508, G3512 and G3516 Engines Crankshaft - Install
C7 PETROLEUM Petroleum Engine Inlet and Exhaust Valves - Remove and Install
C13 and C15 On-Highway Engines Emissions Certification Film
C7 PETROLEUM Petroleum Engine Inlet and Exhaust Valve Springs - Remove and Install
Air Conditioning and Heating R134a for All Caterpillar Machines Identifying the Air Conditioning System
C280 Marine Propulsion Engines Intermittent Engine Shutdown
C280 Marine Auxiliary Engines Self-Diagnostics
G3508, G3512 and G3516 Engines Crankshaft - Remove
C7 On-Highway Engine Clean Gas Induction Cooler - Remove and Install
C7 PETROLEUM Petroleum Engine Exhaust Manifold - Remove and Install
C3.3 Industrial Engine Crankshaft Rear Seal - Install
AccuGrade® GPS (CD700) Radio Utility
C7 PETROLEUM Petroleum Engine Engine Oil Filter Base - Remove
G3500 A3 Engines Grounding Practices
G3500 A3 Engines General Information (Electronic Control System)
AccuGrade® GPS (CD700) Receiver Firmware Upgrade
AccuGrade® GPS (CD700) Display Firmware Upgrade
AccuGrade® GPS (CD700) Sensor Firmware Upgrade
C15 Industrial Engine Powertrain Data Link Circuit - Test
C7 PETROLEUM Petroleum Engine Engine Oil Filter Base - Disassemble
C7 On-Highway Engine Clean Gas Induction Valve - Remove
2006/03/27 Sealing and Installing the Flywheel Housing {1157, 7555}
G3500 A3 Engines Engine Governing - Adjust