Fuel Injectors
Show/hide table
Illustration 1 | g00908211 |
Fuel injector clamp |
(1) Tighten the bolt in the clamp for the fuel injector to the following torque. ...
The fuel injector should be tested at the pressure in Table 1.
Leakage in 10 seconds ... 0 drops
Show/hide table
Service setting for the Fuel Injector |
Injection Pressure |
|
Caterpillar Information System:
C3.3 Industrial Engine Engine Oil Pressure
C3.3 Industrial Engine Fuel Injection Lines - Remove
CX31 On-Highway Transmission Visual Inspection
Battery Charger Power Supply Circuit Fuse Is Too Small on 3456 and 3406 Common Design Generator Set Packages{1406, 1417} Battery Charger Power Supply Circuit Fuse Is Too Small on 3456 and 3406 Common Design Generator Set Packages{1406, 1417}
C7 Engines for Combat and Tactical Vehicles 0102-04 Boost Pressure voltage low (25)
C3.3 Industrial Engine Fuel Filter Base - Remove and Install
C3.3 Industrial Engine Fuel Transfer Pump
C3.3 Industrial Engine Fuel Priming Pump - Remove and Install
C4.4 (Mech) Industrial Engine Water Pump - Inspect
C4.4 (Mech) Industrial Engine Walk-Around Inspection
C3.3 Industrial Engine Flywheel Housing - Inspect
C3.3 Industrial Engine Severe Service Application - Check
C3.3 Industrial Engine Lifter Group
C7 and C9 Marine Engines CID 0001 FMI 11 Cylinder #1 Injector fault
C7 and C9 Marine Engines CID 0002 FMI 11 Cylinder #2 Injector fault
C7 and C9 Marine Engines CID 0003 FMI 11 Cylinder #3 Injector fault
C7 and C9 Marine Engines CID 0004 FMI 11 Cylinder #4 Injector fault
TH48-E80 Petroleum Transmission Gear Pump (Transmission)
C3.3 Industrial Engine Cylinder Head Valves
C7 and C9 Marine Engines CID 0005 FMI 11 Cylinder #5 Injector fault
C3.3 Industrial Engine Fuel Injection Lines - Install
C7 and C9 Marine Engines CID 0006 FMI 11 Cylinder #6 Injector fault
C3.3 Industrial Engine Crankcase Breather
C3.3 Industrial Engine Fuel Injector Cover - Remove and Install - If Equipped