Fuel Injection Lines - Remove
Start By:
- If equipped, remove the cover for the fuel injectors. Refer to this Disassembly and Assembly Manual, "Fuel Injector Cover - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates. |
- Disconnect the fuel injection lines (1) at the fuel injectors (2).
- Disconnect the fuel injection lines (1) at the fuel injection pump (3).
- If it is necessary remove the clamps for the fuel injection lines or loosen the clamps for the fuel injection lines. Remove the fuel injection lines (1).
- Install dust caps onto the ports of the fuel injectors and onto the ports of the fuel injection pump. Install dust caps onto both ends of the fuel injection lines.
Show/hide table
Illustration 1 | g00955826 |
Typical example |
Caterpillar Information System:
CX31 On-Highway Transmission Visual Inspection
Battery Charger Power Supply Circuit Fuse Is Too Small on 3456 and 3406 Common Design Generator Set Packages{1406, 1417} Battery Charger Power Supply Circuit Fuse Is Too Small on 3456 and 3406 Common Design Generator Set Packages{1406, 1417}
C7 Engines for Combat and Tactical Vehicles 0102-04 Boost Pressure voltage low (25)
C3.3 Industrial Engine Fuel Filter Base - Remove and Install
C3.3 Industrial Engine Fuel Transfer Pump
C3.3 Industrial Engine Fuel Priming Pump - Remove and Install
C4.4 (Mech) Industrial Engine Water Pump - Inspect
C4.4 (Mech) Industrial Engine Walk-Around Inspection
C3.3 Industrial Engine Flywheel Housing - Inspect
C3.3 Industrial Engine Severe Service Application - Check
C3.3 Industrial Engine Radiator - Clean
3512B Oil Well Servicing Engine (ADEM III) Event Code List
C3.3 Industrial Engine Engine Oil Pressure
C3.3 Industrial Engine Fuel Injectors
C3.3 Industrial Engine Lifter Group
C7 and C9 Marine Engines CID 0001 FMI 11 Cylinder #1 Injector fault
C7 and C9 Marine Engines CID 0002 FMI 11 Cylinder #2 Injector fault
C7 and C9 Marine Engines CID 0003 FMI 11 Cylinder #3 Injector fault
C7 and C9 Marine Engines CID 0004 FMI 11 Cylinder #4 Injector fault
TH48-E80 Petroleum Transmission Gear Pump (Transmission)
C3.3 Industrial Engine Cylinder Head Valves
C7 and C9 Marine Engines CID 0005 FMI 11 Cylinder #5 Injector fault
C3.3 Industrial Engine Fuel Injection Lines - Install
C7 and C9 Marine Engines CID 0006 FMI 11 Cylinder #6 Injector fault