C7 and C9 On-Highway Engines Caterpillar


0168-00 Excessive ECM Battery Power (17)

Usage:

C9 9DG
产生此代码的情况:

该状况说明发动机运转期间发动机控制模块 (ECM) 的蓄电池供电电路电压过高。

ECM 检测到下述情况时:

  • 对于 12 伏系统,ECM 的蓄电池供电电路电压高于 16 伏超过 0.5 秒钟。

  • 对于 24 伏系统,ECM 的蓄电池供电电路电压高于 32 伏超过 0.5 秒钟。

ECM 还检测到下述情况:

  • 发动机控制置于接通模式。

  • 发动机不能进行起动盘车。

  • 发动机正运转。

  • ECM 至少已通电三秒钟。

系统响应:

ECM 将记录诊断代码。 检查发动机指示灯和报警指示灯可能亮起,就像点火开关刚转到接通位置后起动发动机一样。

测试步骤 1. 进行以下的诊断步骤: 点火钥匙开关电路和蓄电池供电电路 - 测试

结果:

  • 正常 - 停止

Caterpillar Information System:

C-15 Petroleum Engine Auxiliary Water Pump - Install
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Clutch Pedal Position Switch Circuit - Test
C1.5 and C2.2 Generator Sets Engine Crankcase Breather - Clean/Replace
3054E Industrial Engine Exhaust Manifold - Remove and Install
C11 and C13 Industrial Engines Cylinder Block
C-15 Petroleum Engine Auxiliary Water Pump - Remove
C13 Engine for Combat and Tactical Vehicles Engine Oil Pan
C11 and C13 Petroleum Engines Engine Oil Pan
C11 and C13 Industrial Engines Engine Oil Pan
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Engine Vibration Troubleshooting
3054E Industrial Engine Valve Mechanism Cover - Remove and Install
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Fuel System - Prime
3054E Industrial Engine Cylinder Head - Remove
UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Serial Number Plate
C1.5 and C2.2 Generator Sets Generator Set Installation
C15 and C18 Petroleum Generator Sets Engine - Clean
G3520B Engines Jacket Water to Engine Oil Differential Temperature (Low)
3054E Industrial Engine Cylinder Head - Install
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Cruise Control Switch Circuit - Test
Additional Information for the Customer Communication Module (CCM) that Is Used on Series 3500 and Series 3600 Gas Applications{1926} Additional Information for the Customer Communication Module (CCM) that Is Used on Series 3500 and Series 3600 Gas Applications{1926}
3126B and 3126E On-highway Engines 0022-11 Primary to Secondary Engine Speed Signal Calibration (42)
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Diagnostic Enable Switch Circuit - Test
C13 Engine for Combat and Tactical Vehicles Crankshaft Seals
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Fan Override Switch Circuit - Test
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.