Auxiliary Water Pump - Remove
Removal Procedure
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove clamp (1) and clamp (2) from auxiliary water pump (5) .
Show/hide table
 | |
| Illustration 1 | g01060943 |
- Attach a suitable lifting device to auxiliary water pump (5). The weight of the auxiliary water pump is approximately 23 kg (50 lb).
- Remove nuts (3) .
- Remove auxiliary water pump (5) from the front housing.
- Remove gasket (4) from the front housing.
Caterpillar Information System:
C13 Engine for Combat and Tactical Vehicles Engine Oil Pan
C11 and C13 Petroleum Engines Engine Oil Pan
C11 and C13 Industrial Engines Engine Oil Pan
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Engine Vibration Troubleshooting
3054E Industrial Engine Valve Mechanism Cover - Remove and Install
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Fuel System - Prime
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Fuel Injection Timing - Check
C1.5 and C2.2 Generator Sets Additional Messages
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Electrical System
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Basic Engine
C11 and C13 On-Highway Engines Electronic Unit Injector Wiring
3126B Marine Engines Throttle Position Sensor - Calibrate
C11 and C13 Industrial Engines Cylinder Block
3054E Industrial Engine Exhaust Manifold - Remove and Install
C1.5 and C2.2 Generator Sets Engine Crankcase Breather - Clean/Replace
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Clutch Pedal Position Switch Circuit - Test
C-15 Petroleum Engine Auxiliary Water Pump - Install
C7 and C9 On-Highway Engines 0168-00 Excessive ECM Battery Power (17)
3054E Industrial Engine Cylinder Head - Remove
UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Serial Number Plate
C1.5 and C2.2 Generator Sets Generator Set Installation
C15 and C18 Petroleum Generator Sets Engine - Clean
G3520B Engines Jacket Water to Engine Oil Differential Temperature (Low)
3054E Industrial Engine Cylinder Head - Install