Auxiliary Water Pump - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position gasket (4) on the front housing.
Show/hide table
Illustration 1 | g01060943 |
- Attach a suitable lifting device to auxiliary water pump (5). The weight of the auxiliary water pump is approximately 23 kg (50 lb). Position the auxiliary water pump on the front housing.
- Install nuts (3) .
- Position the elbow on the auxiliary water pump and install clamp (1). Tighten the clamp to a torque of 20 N·m (15 lb ft). Position the elbow on the auxiliary water pump and install clamp (2). Tighten the clamp to a torque of 20 N·m (15 lb ft).
Caterpillar Information System:
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Clutch Pedal Position Switch Circuit - Test
C1.5 and C2.2 Generator Sets Engine Crankcase Breather - Clean/Replace
3054E Industrial Engine Exhaust Manifold - Remove and Install
C11 and C13 Industrial Engines Cylinder Block
C-15 Petroleum Engine Auxiliary Water Pump - Remove
C13 Engine for Combat and Tactical Vehicles Engine Oil Pan
C11 and C13 Petroleum Engines Engine Oil Pan
C11 and C13 Industrial Engines Engine Oil Pan
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Engine Vibration Troubleshooting
3054E Industrial Engine Valve Mechanism Cover - Remove and Install
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Fuel System - Prime
C1.5 and C2.2 Engines For Caterpillar Built Marine Generator Sets Fuel Injection Timing - Check
C7 and C9 On-Highway Engines 0168-00 Excessive ECM Battery Power (17)
3054E Industrial Engine Cylinder Head - Remove
UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Serial Number Plate
C1.5 and C2.2 Generator Sets Generator Set Installation
C15 and C18 Petroleum Generator Sets Engine - Clean
G3520B Engines Jacket Water to Engine Oil Differential Temperature (Low)
3054E Industrial Engine Cylinder Head - Install
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Cruise Control Switch Circuit - Test
Additional Information for the Customer Communication Module (CCM) that Is Used on Series 3500 and Series 3600 Gas Applications{1926} Additional Information for the Customer Communication Module (CCM) that Is Used on Series 3500 and Series 3600 Gas Applications{1926}
3126B and 3126E On-highway Engines 0022-11 Primary to Secondary Engine Speed Signal Calibration (42)
3406E, C-10, C-12, C-15, C-16 and C-18 On-highway Engines Diagnostic Enable Switch Circuit - Test
C13 Engine for Combat and Tactical Vehicles Crankshaft Seals