1980/11/24 Caterpillar


Use Fluid-Type Vibration Damper To Control Vibrations{1205,3305}

Usage:


3408 Marine Engines Equipped With 7211 Marine Transmission

A new fluid-type vibration damper is used on 3408 Marine Engines with Serial Numbers 99U1416-Up. See the article "Fluid-Type Vibration Damper Now Used Instead Of Rubber Type Damper", on page 7 of the June 26, 1978 Service Magazine.

It is also important to install a fluid-type vibration damper on earlier 3408 Marine Engines when used with a 7211 Marine Transmission. Use of the former rubber-type vibration damper in this application can cause damage to the transmission.

Caterpillar Information System:

1980/11/24 New Aftercooler Core Has Copper-Nickel Tubes For Increased Strength{1063,1064}
1980/11/24 New Decals Permit Easier Identification Of Fuel System Settings On Most Truck Engines{7557}
1980/11/17 Some Remanufactured 3406 Engines Have The Wrong Reference Serial Number On The Identification Plate{7557,1000}
1980/11/17 Use Dust Cap To Prevent Freon Leakage From Air Conditioner; Cap Is Available As Replacement Part{7320}
1980/11/17 Tee-Test Plug And Pressure Tap (Connection) Plugs Can Be Tightened To A Higher Torque To Prevent Leaks{5050,0651}
1980/11/17 6V4021 Piston Ring Compressor Group Available{1215,1214,0622}
1980/11/17 Two Thinner Spacers Available For Use During Adjustment Of Off-Engine Timing Dimension{1251,0653}
1980/11/17 Coolant Conditioner Elements Are Now Available For 3208 Engines{1350}
1980/11/17 Check For Correct Spring Retainer On Oil Pump Bypass Valve When Oil Pan Is Removed{1315,1302}
1980/11/17 Improved Cable Assembly For Mechanical Shut-Off Group{7418}
1980/11/10 6V3147 Main Bearing Wrench Now Available{1203,0612}
1980/11/10 Special Tools Available To Tighten Retainer Nuts For Clutch Drive Hubs Of 7211 And 7221 Marine Transmissions{0612,0626,3302}
1980/11/24 New Gasket Improves Operation Of Shut-Off Groups{7418,7403}
1980/11/24 6V4008 Valve Seat Extractor Now Available{1103,0622}
1980/11/24 Replacement Wheel Available For Service Of 6V97 Engine Stand Group{0626}
1980/12/01 Direct Inquiry Service Information Retrieval System (SIRS) Available To U.S. And Canadian Dealers{0374}
1980/12/01 Exhaust Manifold And Air Lines Groups Changed To Prevent Exhaust Leakage And Damage To Manifold Gaskets And Mounting Studs{1059,1061}
1980/12/01 Larger Plug Used In The Ends Of The Rocker Arm Shaft Assembly{1102}
1980/12/01 New Service Handle Kit Permits Cab Door To Be Opened From Inside While Locked (Fastened With Lock){7308,7301}
1980/12/01 New Front Housing Assembly And Gaskets Used{1162,1166,1151}
1980/12/01 Different O-Ring Seal Now Used On The Oil Pump Suction Tube{1307,1304}
1980/12/01 Inspect All Engine Oil And Fuel Filter Elements Before Installation{1000,1261,1318}
1980/12/01 6V4085 Torque Multiplier Group Available{0614}
1980/12/15 New Bearing Sizes And Identification Codes For AiResearch Remanufactured Turbocharger Cartridges{1053}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.