Installation Procedure
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 4C-8982 (1)     | Installer     | 1     |
438-9547 (2) | Installer     | 1     | |
7F-8022 | Bolt     | 1     |
( 1 ) | Use to install 9Y-9895 seal |
( 2 ) | Use to install 362-8853 seal |
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install crankshaft front seal (1) and wear sleeve (2) with Tool (A) , as follows:
- Use 4C-9500 Quick Cure Primer to clean the outside diameter of crankshaft (3) and the inside diameter of wear sleeve (2) .
- Apply 4C-9507 Compound to the outside diameter of crankshaft (3) and the inside diameter of wear sleeve (2) .
- Place crankshaft front seal (1) and wear sleeve (2) on the front of crankshaft (3) . Install Tool (A) and tighten until the inside surface of the Installer comes in contact with the end of the crankshaft.
Note: Once the seal and the wear sleeve are separated, these components cannot be used again. Refer to Special Instruction, SMHS8508 before the seal is serviced.
Note: Do not use any type of lubricant during the installation of the crankshaft seal and wear sleeve.
Note: Before installing the wear sleeve, inspect the crankshaft for scratches or any distortion on the surface of the crankshaft that may lead to an out of round condition. Use a polishing cloth to clean the imperfections on the crankshaft.
Illustration 1 | g00488110 |
End By: Install the vibration damper and the pulley. Refer to Disassembly and Assembly, "Vibration Damper and Pulley - Remove and Install".