Flywheel
Show/hide table
Illustration 1 | g00447234 |
Note: Refer to System Operation, Testing and Adjusting for the correct method of inspecting the flywheel.
(1) Bolt
(2) Ring gear
(3) Shoulder
The following instructions should be used during installation of the ring gear:
- Install the flywheel ring gear. Face the "part number" on ring gear (2) toward the engine block. The flywheel ring gear must be installed against shoulder (3) . The flywheel ring gear can be heated for installation. Do not use a torch.
Maximum temperature ... 320°C (608°F)
- Tighten bolts (1) that hold the flywheel to the crankshaft.
Tighten to the following torque. ... 120 ± 20 N·m (90 ± 15 lb ft)
Caterpillar Information System:
3126 Industrial Engine Flywheel
320B, 320B L and 320B N Excavators Battery or Battery Cable - Inspect/Replace
3126 Industrial Engine Air Compressor
3126 Truck Engine Piston and Rings
3208 Marine Engine Manual Stop Procedure
3126 Industrial Engine Engine Oil Filter Base - Remote Filter Adapter
3126 Industrial Engine Coolant Conditioner Base
3126 Truck Engine Turbocharger
3126 Industrial Engine Air Inlet Elbow
3126 Truck Engine Inlet Manifold
C-10 and C-12 Truck Engines Basic Block
3406E Truck Engines Compression Brake
3126 Industrial Engine Belt Tensioner - If Equipped
3126 Industrial Engine Flywheel Housing
3126 Industrial Engine Engine Oil Pan
3126 Industrial Engine Engine Oil Pressure
3208 Marine Engine After Starting Engine
3126 Truck Engine Front Housing and Covers
3126 Industrial Engine Crankshaft Pulley
3126 Industrial Engine Crankshaft Pulley
3208 Marine Engine Engine and Marine Transmission Operation
3208 Marine Engine Trolling
3126 Industrial Engine Engine to Transmission Adapter
3126 Industrial Engine Electric Starting Motor