Turbocharger
Show/hide table
Illustration 1 | g00445217 |
Typical example |
Note: Apply 4C-5598 Anti-seize Compound to the threads prior to assembly.
(1) Tighten locknuts to the following torque. ... 54 ± 5 N·m (40 ± 4 lb ft)
(2) Exhaust inlet
(3) Exhaust outlet
(4) Air inlet
End play for the shaft ... 0.067 ± 0.016 mm (0.0026 ± 0.0006 inch)
(5) Tighten bolts to the following torque. ... 7.3 ± 0.5 N·m (65 ± 4 lb in)
(6) Tighten bolts to the following torque. ... 15.8 ± 0.5 N·m (12 ± 0.4 lb ft)
Note: Put clean engine oil in the oil inlet of the turbocharger after assembly or before installation. This will provide lubrication during start-up and during storage.
Caterpillar Information System:
3126 Industrial Engine Air Inlet Elbow
3126 Truck Engine Inlet Manifold
C-10 and C-12 Truck Engines Basic Block
3406E Truck Engines Compression Brake
3126B Marine Engine Rear Seal Carrier - If Equipped
C-10 and C-12 Truck Engines Compression Brake
3126B and 3126E Truck Engines Exhaust Elbow
EMCPII+ for Gas Engines Symbols
C-10 and C-12 Truck Engines Electrical System
Electronic Modular Control Panel II+ (EMCP II+) Starting Motor Magnetic Switch - Test - 3412C, 3508, 3512, and 3516 MUI Engines Only
3126 Truck Engine Exhaust Manifold
3126 Truck Engine Camshaft
3126 Industrial Engine Coolant Conditioner Base
3126 Industrial Engine Engine Oil Filter Base - Remote Filter Adapter
3208 Marine Engine Manual Stop Procedure
3126 Truck Engine Piston and Rings
3126 Industrial Engine Air Compressor
320B, 320B L and 320B N Excavators Battery or Battery Cable - Inspect/Replace
3126 Industrial Engine Flywheel
3126 Industrial Engine Flywheel
3126 Industrial Engine Belt Tensioner - If Equipped
3126 Industrial Engine Flywheel Housing
3126 Industrial Engine Engine Oil Pan
3126 Industrial Engine Engine Oil Pressure