3406E and 3456 Industrial Engines Caterpillar

Battery or Battery Cable - Disconnect

Usage:

3456 3LW

Turn the start switch to the OFF position. Turn the ignition switch (if equipped) to the OFF position and remove the key and all electrical loads.

Disconnect the cable from ground. One cable connects to the frame and one cable connects to battery negative. Make sure the cable cannot contact the surface from where it was removed.

Disconnect the negative battery terminal at the battery that goes to the start switch. Ensure that the cable cannot contact the terminal. When four 12 volt batteries are involved, the negative side of two batteries must be disconnected.

Tape the leads in order to help prevent accidental starting.

Proceed with necessary system repairs. Reverse the steps in order to reconnect all of the cables.

Caterpillar Information System:

C-10 and C-12 Truck Engines General Information

SPP101 Skid Mounted Pumper Belts - Inspect/Adjust/Replace

C-10 and C-12 Truck Engines Engine Design

C-10 and C-12 Truck Engines Engine Design

3126 Truck Engine (Military) Starting the Engine

G3612 and G3616 Engines Electrohydraulic System Oil - Change

Electronic Modular Control Panel II+ (EMCP II+) AL Fault Codes

G3612 and G3616 Engines Electrohydraulic System - Inspect

G3612 and G3616 Engines Electrohydraulic System - Check/Adjust

G3300 Engines Alternator - Inspect

3600 Heavy Fuel Engines Engine Oil Temperature Regulator - Replace

3600 Heavy Fuel Engines Cooling System Water Temperature Regulator - Replace

C-10 and C-12 Truck Engines Glossary of Electronic Control Terms

Installation And Commissioning Procedures For The 3600 Marine Monitoring System{1901} Installation And Commissioning Procedures For The 3600 Marine Monitoring System{1901}

3126B Truck Engine Customer Specified Parameters

3126E and 3126B Commercial and Truck Engines Emissions Certification Film

3126E Truck Engines Engine Operation

3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Camshaft

C-10 and C-12 Truck Engines Electronic Control System Components

3406E and 3456 Engines for Caterpillar Built Machines Fuel System

318B Excavator Machine System Specifications Front Idler

3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Connecting Rod

3126 Truck Engine Engine Design

3512 Industrial Engine Model View Illustrations