Electrohydraulic System Oil - Change
Ensure that the engine cannot start during this procedure.
Show/hide table
 | |
| Illustration 1 | g00792335 |
(1) Oil filler cap (2) Valve | |
- Remove oil filler cap (1) .
- Place a suitable container under valve (2). Open the valve. Allow the oil to drain. After the oil has drained, close the valve.
Note: Drain the oil into a suitable container. Dispose of fluids according to local regulations.
- Pour the proper oil into the oil filler. Clean the oil filler cap. Install the oil filler cap.
Note: For the proper oil to use, refer to this Operation and Maintenance Manual, "Refill Capacities and Recommendations" topic (Maintenance Section).
- Clean up any oil that may have spilled.
Caterpillar Information System:
Electronic Modular Control Panel II+ (EMCP II+) AL Fault Codes
G3612 and G3616 Engines Electrohydraulic System - Inspect
G3612 and G3616 Engines Electrohydraulic System - Check/Adjust
G3300 Engines Alternator - Inspect
3600 Heavy Fuel Engines Engine Oil Temperature Regulator - Replace
3600 Heavy Fuel Engines Cooling System Water Temperature Regulator - Replace
C-10 and C-12 Truck Engines Air Inlet and Exhaust System
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Design
3406E Generator Set Engines Fuel System - Prime
3126E and 3126B Commercial and Truck Engines Diagnostic Flash Code Retrieval
3126E and 3126B Commercial and Truck Engines Diagnostic Lamp
3406E Generator Set Engines Fuel System Secondary Filter - Replace
3126 Truck Engine (Military) Starting the Engine
C-10 and C-12 Truck Engines Engine Design
C-10 and C-12 Truck Engines Engine Design
SPP101 Skid Mounted Pumper Belts - Inspect/Adjust/Replace
C-10 and C-12 Truck Engines General Information
3406E and 3456 Industrial Engines Battery or Battery Cable - Disconnect
C-10 and C-12 Truck Engines Glossary of Electronic Control Terms
Installation And Commissioning Procedures For The 3600 Marine Monitoring System{1901} Installation And Commissioning Procedures For The 3600 Marine Monitoring System{1901}
3126B Truck Engine Customer Specified Parameters
3126E and 3126B Commercial and Truck Engines Emissions Certification Film
3126E Truck Engines Engine Operation
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Camshaft