3034 Engine for Caterpillar Built Machines Caterpillar


Fuel Transfer Pump

Usage:

3034 3NW



Illustration 1g00378476

Fuel transfer pump

Type ... Diaphragm

Method of drive ... Camshaft for fuel injection pump

Output pressure during the first ten seconds of cranking.

Normal pressure ... 42 to 70 kPa (6 to 10 psi)
Minimum pressure ... 31 kPa (4.5 psi)

Tighten the four mounting bolts to the following torque. ... 22 N·m (16 lb ft)

Refer to the Testing and Adjusting, "Fuel System Pressure - Test" in order to test the operation of the fuel transfer pump.

Note: When the fuel transfer pump is installed on the engine, make sure that the camshaft for the fuel injection pump is on minimum lobe lift and that the bolts are evenly tightened. Failure to follow this procedure can cause the loss of maximum engine power and damage to the fuel transfer pump.

Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.