Fuel System - Prime
Show/hide table
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. |
Show/hide table
NOTICE |
---|
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over disconnected fuel system component. |
Prime the fuel system in order to fill dry fuel filters and purge air from the fuel system. Prime the fuel system after the following occurrences:
- The fuel filter elements are replaced.
- The engine is run dry.
- The fuel lines have been disconnected.
- The engine has been overhauled.
- The engine is removed from storage.
- Open the vent plugs for the fuel filters.
Show/hide table
Illustration 1 | g00366372 |
Vent plugs for the fuel filters |
- Operate the fuel priming pump of the vessel until fuel appears at the openings of the vent plugs. Operate the priming pump until the fuel flows free of air bubbles. Clean up any spilled fuel immediately.
- Tighten the vent plugs.
Priming the Fuel System After Disconnecting Fuel Lines or After an Overhaul
- Loosen the connector that is above the fuel pressure regulator valve. Use a cloth to catch any fuel and clean up any fuel that overflows.
- Operate the fuel priming pump of the vessel until fuel appears at the opening of the connector. Operate the priming pump until the fuel flows free of air bubbles. Clean up any spilled fuel immediately.
- Tighten the connector that is above the fuel pressure regulator valve.
Caterpillar Information System:
G3612 and G3616 Engines Ignition System
3618 Engine Engine Mounts - Check
3412 Generator Set Engines Engine Oil Filter Base
3412 Generator Set Engines Engine Oil Pressure Sensor
3412E and C30 Marine Engines Cooling System
3412 Generator Set Engines Lubrication System
3412C Engine Engine Oil Pump
3306C Truck Engine Pressure Switch (Air Inlet Heater)
3306C Truck Engine Temperature Sensor (Air Inlet Heater)
3412 Generator Set Engines Air Inlet And Exhaust System
3306B Industrial Engine Air Compressor
3306C Truck Engine Shutoff Solenoid
3412 Generator Set Engines Cylinder Block
3034 Engine for Caterpillar Built Machines Engine Design
3034 Engine for Caterpillar Built Machines Fuel Transfer Pump
3412 Generator Set Engines Inlet Air Temperature Sensor
3034 Engine for Caterpillar Built Machines Engine Oil Pan
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Oil Pressure
3408E and 3412E Engines for Caterpillar Built Machines Camshaft Bearings
3412 Generator Set Engines Coolant Temperature Switch
3034 Engine for Caterpillar Built Machines Fuel Injection Nozzles
3412 Generator Set Engines Cylinder Liner
3412 Generator Set Engines Electrical System
3034 Engine for Caterpillar Built Machines Water Temperature Regulator