Removal Procedure
Show/hide table
Table 1
Required Tools     |
Tool     |
Part Number     |
Part Description     |
Qty     |
A     |
138-7575     |
Link Bracket     |
2     |
Show/hide table
|
NOTICE |
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
|
Note: Put identification marks on all hoses, on all hose assemblies, and on all harness assemblies for installation purposes. Plug all hose assemblies. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
- Lower all implements to the ground.
- Release the system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
- Drain the hydraulic system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Capacities - Refill" for the capacity of the hydraulic tank. Refer to Operation and Maintenance Manual, "Hydraulic System Oil - Change".
Show/hide table
|
|
|
Illustration 1 | g01119509 |
- Remove bolts (3) and plate (2). Repeat for the other side. Remove floor mat (1) .
Show/hide table
|
|
|
Illustration 2 | g01817724 |
- Remove knobs (4). Remove boots (5) .
Show/hide table
|
|
|
Illustration 3 | g01817717 |
- Remove cover (6) .
Show/hide table
|
|
|
Illustration 4 | g01817733 |
- Remove bolts (8). Remove pedal assembly (7). Remove mat (9) .
Show/hide table
|
|
|
Illustration 5 | g01817744 |
- Remove pins (11). Remove bolts (10) .
Show/hide table
|
|
|
Illustration 6 | g01818156 |
- Remove clips (12), and clips (13) .
Show/hide table
|
|
|
Illustration 7 | g01818515 |
- Disconnect hose assembly (14), and hose assembly (15) .
Show/hide table
|
|
|
Illustration 8 | g01818576 |
- Attach Tooling (A) and a suitable lifting device to bank valve (17) for the backhoe. The weight of bank valve (17) for the backhoe is approximately 80 kg (175 lb). Remove bolts (16) and remove bank valve (16) .