Engine Front Support
Usage:
Remove & Install Engine Front Support
Start By:
a. remove vibration damper and pulley
1. Remove the bolts that hold the engine front support to the base.
2. Fasten Tool (A) to the cylinder head as shown. Fasten a hoist to Tool (A) and the lifting bracket on the other cylinder head.
3. Lift the front of the engine enough so that blocks (1) can be installed under the oil pan as shown. The weight of the front end of the engine is approximately 1134 kg (2500 lb).
4. Remove four bolts (1) and engine front support (2).
5. Reverse Steps (1) thru (4) for installation.
End By:
a. install vibration damper and pulley
Caterpillar Information System:
3408 & 3412 INDUSTRIAL ENGINES Crankshaft Front Seal & Wear Sleeve
3408 & 3412 INDUSTRIAL ENGINES Vibration Damper & Pulley
3408 & 3412 INDUSTRIAL ENGINES Spacer Plates
3408 & 3412 INDUSTRIAL ENGINES Valve Seat Inserts
3408 & 3412 INDUSTRIAL ENGINES Bridge Dowels
3408 & 3412 INDUSTRIAL ENGINES Valve Guides
3408 & 3412 INDUSTRIAL ENGINES Valves
3408 & 3412 INDUSTRIAL ENGINES Cylinder Head
3408 & 3412 INDUSTRIAL ENGINES Valve Lifters & Push Rods
3408 & 3412 INDUSTRIAL ENGINES Rocker Shaft Assembly
3408 & 3412 INDUSTRIAL ENGINES Valve Covers
3408 & 3412 INDUSTRIAL ENGINES Exhaust Manifold
3408 & 3412 INDUSTRIAL ENGINES Timing Gear Cover
3408 & 3412 INDUSTRIAL ENGINES Camshaft
3408 & 3412 INDUSTRIAL ENGINES Camshaft Bearings
3408 & 3412 INDUSTRIAL ENGINES Timing Gears
3408 & 3412 INDUSTRIAL ENGINES Crankshaft Rear Seal & Wear Sleeve
3408 & 3412 INDUSTRIAL ENGINES Flywheel
3408 & 3412 INDUSTRIAL ENGINES Flywheel Housing
3408 & 3412 INDUSTRIAL ENGINES Pistons
3408 & 3412 INDUSTRIAL ENGINES Cylinder Liners
3408 & 3412 INDUSTRIAL ENGINES Connecting Rod Bearings
3408 & 3412 INDUSTRIAL ENGINES Crankshaft
3408 & 3412 INDUSTRIAL ENGINES Crankshaft Main Bearings