Valve Guides
Usage:
Remove Valve Guides
Start By:
a. remove valves
1. Remove valve guides with Tool (A).
Install Valve Guides
1. Put clean engine oil on the outside of the valve guides.
2. Use Tool (A) to install the valve guides. Install the valve guides so that dimension (X) is 32.3 ± 0.8 mm (1.27 ± .03 in). The inside diameter of the guides must be 9.479 ± 0.020 mm (.3732 ± .0008 in). The maximum diameter for used guides is 9.545 mm (.3758 in).
End By:
a. install valves
Caterpillar Information System:
3408 & 3412 INDUSTRIAL ENGINES Valves
3408 & 3412 INDUSTRIAL ENGINES Cylinder Head
3408 & 3412 INDUSTRIAL ENGINES Valve Lifters & Push Rods
3408 & 3412 INDUSTRIAL ENGINES Rocker Shaft Assembly
3408 & 3412 INDUSTRIAL ENGINES Valve Covers
3408 & 3412 INDUSTRIAL ENGINES Exhaust Manifold
3408 & 3412 INDUSTRIAL ENGINES Turbocharger (Engine With Four Turbochargers)
3408 & 3412 INDUSTRIAL ENGINES Turbochargers (3408 Engine)
3408 & 3412 INDUSTRIAL ENGINES Aftercooler Core
3412 INDUSTRIAL ENGINES Schematic
3412 INDUSTRIAL ENGINE Testing & Adjusting
3412 INDUSTRIAL ENGINE Systems Operation
3408 & 3412 INDUSTRIAL ENGINES Bridge Dowels
3408 & 3412 INDUSTRIAL ENGINES Valve Seat Inserts
3408 & 3412 INDUSTRIAL ENGINES Spacer Plates
3408 & 3412 INDUSTRIAL ENGINES Vibration Damper & Pulley
3408 & 3412 INDUSTRIAL ENGINES Crankshaft Front Seal & Wear Sleeve
3408 & 3412 INDUSTRIAL ENGINES Engine Front Support
3408 & 3412 INDUSTRIAL ENGINES Timing Gear Cover
3408 & 3412 INDUSTRIAL ENGINES Camshaft
3408 & 3412 INDUSTRIAL ENGINES Camshaft Bearings
3408 & 3412 INDUSTRIAL ENGINES Timing Gears
3408 & 3412 INDUSTRIAL ENGINES Crankshaft Rear Seal & Wear Sleeve
3408 & 3412 INDUSTRIAL ENGINES Flywheel