Valve Covers
Usage:
Remove Valve Covers
1. Loosen two clamps (1). Remove hose (2) from between crankcase ventilator valve (3) and the air inlet manifold.
2. Remove eight bolts (4) and valve cover (5).
3. Remove the gasket from the valve cover.
4. Do Steps 1 through 3 for the other valve cover.
Install Valve Covers
1. Put the gasket in position in the valve cover.
2. Put valve cover (5) in position. Install eight bolts (4) that hold it in place.
3. Tighten bolts (4) to a torque of 17 ± 3 N·m (13 ± 2 lb ft)in the number sequences shown.
4. Put hose (2) in position between the air inlet manifold and crankcase ventilator valve (3). Put two hose clamps (1) in position. Tighten the hose clamps to a torque of2.3 ± 0.2 N·m (20 ± 2 lb in).
Caterpillar Information System:
3208 INDUSTRIAL ENGINE Air Cleaner Assembly
3208 INDUSTRIAL ENGINE Engine Lifting Brackets
3208 INDUSTRIAL ENGINE Oil Level Gauge
3208 INDUSTRIAL ENGINE Aftercooler
3208 INDUSTRIAL ENGINE Air Inlet Manifold
3208 INDUSTRIAL ENGINE Introduction
3208 INDUSTRIAL ENGINE Testing & adjusting
3208 INDUSTRIAL ENGINE Systems Operation
3208 INDUSTRIAL ENGINE Electric Starter Motor
3208 INDUSTRIAL ENGINE Alternators and Regulators
3208 INDUSTRIAL ENGINE Flywheel
3208 INDUSTRIAL ENGINE Pulley And Damper Group
3208 INDUSTRIAL ENGINE Crankcase Ventilator Valves
3208 INDUSTRIAL ENGINE Water Separator
3208 INDUSTRIAL ENGINE Oil Pan
3208 INDUSTRIAL ENGINE Fuel Filter & Fuel Filter Base
3208 INDUSTRIAL ENGINE Water Temperature Regulators
3208 INDUSTRIAL ENGINE Fan Drive
3208 INDUSTRIAL ENGINE Exhaust Manifolds
3208 INDUSTRIAL ENGINE Air Compressor
3208 INDUSTRIAL ENGINE Fuel Injection Lines
3208 INDUSTRIAL ENGINE Fuel Injection Nozzles
3208 INDUSTRIAL ENGINE Rocker Shaft Assemblies & Push Rods
3208 INDUSTRIAL ENGINE Rocker Shaft Assemblies