2006/08/07 Caterpillar

Integrated Toolcarrier:

IT62GSeries II (S/N: AYA1-UP)

IT62G (S/N: AKP1-UP; 6PS1-UP)

Wheel Loader:

950GSeries II (S/N: BAA1-UP; AYB1-UP; AYD1-UP; AYL1-UP; AXR1-UP; AYS1-UP; AXX1-UP)

950G (S/N: 2JS1-UP; 4BS1-UP; 6NS1-UP; 3JW1-UP; 5FW1-UP; 5MW1-UP; 8JW1-UP)

962GSeries II (S/N: BAB1-UP; BAC1-UP; BAD1-UP; AYE1-UP; AYG1-UP; AXS1-UP; AXY1-UP)

962G (S/N: BDP1-UP; 3BS1-UP; 5AS1-UP; 5RS1-UP; 4PW1-UP; 6EW1-UP; 6HW1-UP; 7BW1-UP)

Disassembly and Assembly, SENR1381, "950G, 962G Wheel Loaders and IT62G Integrated Toolcarrier Power Train", "Differential and Bevel Gear - Install". This module is part of Service Manual, SENR1374, "950G & 962G Wheel Loader and IT62G Integrated Toolcarrier".

A portion of the existing information in this article has been updated. Replace the existing information with the updated information that is provided in this supplement. The remainder of the information in this article is correct.

In Step 15, replace the torque for bolts (9) 240 ± 40 N·m (175 ± 30 lb ft) with the torque 300 ± 40 N·m (220 ± 30 lb ft).

In the note under Step 24, replace the rolling torque for new bearings from 1.8 to 3.6 N·m (16 to 32 lb in) with the rolling torque 1.8 to 7.4 N·m (16 to 65 lb in). Replace the rolling torque for used bearings from 0.9 to 1.8 N·m (8 to 16 lb in) with the rolling torque 0.9 to 3.7 N·m (8 to 33 lb in).

In Step 25, replace the backlash measurement 0.28 ± 0.13 mm (.011 ± .005 inch) with the backlash measurement 0.30 + 0.12 − 0.10 mm (0.012 + 0.005 − 0.004 inch).