G3512H and G3516H Generator Set Engines Caterpillar


Engine Oil Pan - Remove and Install

Usage:

G3512H GF4

拆卸步骤

表 1
所需工具 
工具  零件号  零件描述  数量 
309-2793  负载调平组件 
Loctite RTV 透明硅密封胶 

开始:

  1. 拆下分动箱。


注意

在检查、保养、测试、调整及维修产品时,请小心确保盛接油液。 在打开任何舱室或拆卸任何含有油液的部件前,请准备好盛接液体用的适当容器。



注意

保持所有零件清洁无杂质。

杂质会造成快速磨损並縮短部件使用寿命。


  1. 放掉发动机机油。 有关正确的排放和加注步骤,参考操作和保养手册, "发动机机油和滤清器 - 更换"。


    图 1g03733676

  2. 拆下螺栓 (1 )。


    图 2g03733680


    图 3g03733693

    ------ WARNING! ------

    不适当的吊具会使被吊装设备翻倒,造成伤害和损坏。


  3. 拆下将发动机油底壳 (2)连接到缸体的螺栓 (3)。

  4. 将工具 (A) 和适当的起吊设备连接到发动机吊耳上。 G3520 发动机的重量约为 21600 kg (47620 lb)。 发动机油底壳 (2) 的重量约为 600 kg (1323 lb)

  5. 从发动机油底壳 (2) 上升起发动机。


    图 4g03733835

  6. 将油底壳密封垫 (4) 从发动机油底壳 (2) 上拆下。

安装步骤

  1. 按与拆卸相反的顺序安装发动机油底壳 (2)。


      图 5g03733901

    1. 将工具 (B) 涂抹到油底壳密封垫 (4) 上的 (X) 位置。

Caterpillar Information System:

C9.3 Industrial Engine Engine Control Module - Remove and Install
G3512H and G3516H Generator Set Engines Engine Oil Filter Housing - Assemble
G3512H and G3516H Generator Set Engines Engine Oil Filter Housing - Disassemble
C9.3 Tier 4 Final Engines Cylinder Head Valves
2013/05/10 A New Water Seal Assembly Is Now Used on All 3408 and 3412 Engines {1100, 7555}
C13, C15, and C18 Tier 4 Final Engines Electric Starting Motor
C13, C15, and C18 Tier 4 Final Engines Cylinder Head Valves
C13, C15, and C18 Tier 4 Final Engines Electric Starting Motor
C13, C15, and C18 Tier 4 Final Engines Housing (Front)
Failure of the Electronic Thermostat (ESTAT) on C175-16 Generator Set, Marine, and Petroleum Engines{135V} Failure of the Electronic Thermostat (ESTAT) on C175-16 Generator Set, Marine, and Petroleum Engines{135V}
C9.3 Engines for Caterpillar Built Machines Diesel Exhaust Fluid Module - Assemble
C9.3 Engines for Caterpillar Built Machines Diesel Exhaust Fluid Module - Disassemble
G3512H and G3516H Generator Set Engines Engine Oil Pan - Disassemble
C13, C15, and C18 Tier 4 Final Engines Flywheel
C15 and C18 Industrial Engines Flywheel Housing
C9.3 Tier 4 Final Engines Flywheel
C9.3 Tier 4 Final Engines Flywheel
C9.3 Tier 4 Final Engines Flywheel
C9.3 Marine Engines Flywheel Housing
3176C and 3196 Engines for Caterpillar Built Machines Electric Starting Motor
C4.4 and C7.1 Engines Electrical Power Supply - Test
2013/07/22 A New Oil Mist Detector Mounting Bracket Is Used With Certain 3516C Engines {1336}
G3512H and G3516H Generator Set Engines Engine Oil Pan - Assemble
G3512H and G3516H Generator Set Engines Valve Mechanism Cover - Remove and Install
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.