Engine Control Module - Remove and Install
Removal Procedure
Start By:
- Remove the electronic control (Aftertreatment).
- Disconnect the battery. Refer to Operation and Maintenance Manual, "Battery or Battery Cable - Disconnect".
- Remove bolts (1) and remove cover (2) .
Show/hide table
Illustration 1 | g01947069 |
Show/hide table
Illustration 2 | g01947081 |
- Remove bolts (3) and (4). Position the harness assembly out of the way.
- Remove bolt (7). Disconnect hose assemblies (5) and (8) .
Show/hide table
Illustration 3 | g01947099 |
- Remove plate (6) .
- Remove studs (9). Remove engine control module (10), the washers, and the isolation mounts.
Show/hide table
Illustration 4 | g01947158 |
Installation Procedure
- Install engine control module (10) in reverse order of removal.
- Tighten bolt (3) to a torque of 7 ± 0.5 N·m (62 ± 5 lb in).
Caterpillar Information System:
G3512H and G3516H Generator Set Engines Engine Oil Filter Housing - Assemble
G3512H and G3516H Generator Set Engines Engine Oil Filter Housing - Disassemble
C9.3 Tier 4 Final Engines Cylinder Head Valves
2013/05/10 A New Water Seal Assembly Is Now Used on All 3408 and 3412 Engines {1100, 7555}
C13, C15, and C18 Tier 4 Final Engines Electric Starting Motor
C13, C15, and C18 Tier 4 Final Engines Cylinder Head Valves
C13, C15, and C18 Tier 4 Final Engines Electric Starting Motor
C13, C15, and C18 Tier 4 Final Engines Housing (Front)
Failure of the Electronic Thermostat (ESTAT) on C175-16 Generator Set, Marine, and Petroleum Engines{135V} Failure of the Electronic Thermostat (ESTAT) on C175-16 Generator Set, Marine, and Petroleum Engines{135V}
C9.3 Engines for Caterpillar Built Machines Diesel Exhaust Fluid Module - Assemble
C9.3 Engines for Caterpillar Built Machines Diesel Exhaust Fluid Module - Disassemble
Cat® Detect Object Detection Hardware Generation 4 for Small Off Highway Trucks, Motor Graders, Large Wheel Loaders, Large Wheel Dozers and Articulated Trucks Maintenance Interval Schedule
G3512H and G3516H Generator Set Engines Engine Oil Pan - Remove and Install
G3512H and G3516H Generator Set Engines Engine Oil Pan - Disassemble
C13, C15, and C18 Tier 4 Final Engines Flywheel
C15 and C18 Industrial Engines Flywheel Housing
C9.3 Tier 4 Final Engines Flywheel
C9.3 Tier 4 Final Engines Flywheel
C9.3 Tier 4 Final Engines Flywheel
C9.3 Marine Engines Flywheel Housing
3176C and 3196 Engines for Caterpillar Built Machines Electric Starting Motor
C4.4 and C7.1 Engines Electrical Power Supply - Test
2013/07/22 A New Oil Mist Detector Mounting Bracket Is Used With Certain 3516C Engines {1336}
G3512H and G3516H Generator Set Engines Engine Oil Pan - Assemble