3306 TRUCK ENGINE Caterpillar


Engine Crankcase

Usage:

(1)

1. Measure oil level. Oil should be between the FULL and ADD marks on the dipstick.

2. Add oil if necessary.

(2)Radiator

------ WARNING! ------

Always remove the radiator cap with the engine stopped.

Remove the radiator cap slowly to relieve pressure. Steam can cause personal injury.

Conditioner contains alkali, avoid contact with skin and eyes to prevent personal injury.

------WARNING!--------

If it is necessary to add coolant daily, inspect the cooling system for leaks.

1. Inspect coolant level with the engine stopped and cold. Remove the radiator cap slowly to relieve pressure. Observe the coolant level.

2. Maintain coolant level within 1/2 inch (1 cm) below the top of the fill pipe. Inspect cap gasket and replace if necessary.

(3)Fuel Tank

Drain a cupful of fuel from each tank to remove water or sediment.

(4)Water Separator

1. Close the fuel supply valve (if equipped).
2. Open the separator drain valve (A).
3. Open the separator vent valve (B).
4. After water is drained, close the vent valve and drain valve, and then open the fuel supply line valve.

(4A)Air Cleaner (If Equipped)

1. Inspect air cleaner indicator. If the indicator shows red, stop the engine and service the air cleaner element. Refer to the topic "Engine Air Intake System," under the interval "Every 10,000 Miles or 250 Service Hours.

NOTE: Refer to the truck manufacturer's maintenance manual for procedure to change the air cleaner element.

Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.