Usage:
No. 2 fuel oil and No. 2D diesel fuel are recommended for use in Caterpillar Diesel Truck Engines. The more expensive premium fuels such as No. 1 fuel oil are not necessary for normal operating conditions. In extreme cold temperatures use No. 1 fuel oil or No. 1D diesel fuel.
In selecting a fuel, note that distillate fuels are especially desirable because the fuel is heated to a vaporous state and condensed, thus eliminating all sediment and residue.
There is considerable variation in the composition of fuels distributed under the No. 2 grade classifications. For desirable engine service it is most important to give special attention to cetane no., water and sediment, pour point, cloud point and sulphur content. USE THE LOWEST PRICE DISTILLATE FUEL WHICH MEETS THE FOLLOWING REQUIREMENTS.
Cetane No ... 35 minimum
Water and Sediment ... 1% maximum
Pour Point ... 10°F (6°C) below ambient temperature
Cloud Point ... No higher than ambient temperature
Sulphur Content* ... Adjust oil change period
Gravity ... 32-40 A.P.I. at 60°F (16°C)
*See the topic SULPHUR CONTENT.
Cetane No: This is an indication of a fuel's ignition quality and should not be less than 35 for this engine. For high altitude operation or cold weather starting, a higher cetane number is required.
Water and Sediment. A good clean fuel will contain no more than 0.1% sediment and water. Dirty fuels lead to early filter plugging and in addition can result in the formation of gums and resins reducing filter and engine life.
Pour Point: The pour point of the fuel has no effect on engine performance, as long as the fuel is fluid enough to flow from the fuel tank to the engine. The pour point of the fuel should be at least 10°F (6°C) below the lowest ambient temperature at which the engine must start and operate. In extremely cold temperatures it may be necessary to use No. 1 fuel oil or No. 1D diesel fuel.
Cloud Point: Cloud point is the temperature at which wax crystals become visible and is generally above the pour point of the fuel. The cloud point should be no higher than the lowest atmospheric temperature at which the engine must start to keep the fuel filter elements from plugging with wax crystals.
Sulphur Content: As sulphur content increases, the crankcase oil change periods should be reduced. Fuel containing 0.4% or less sulphur content, use normal oil change periods. If the fuel contains 0.4% to 1.0% sulphur, oil change periods should be reduced to one-half normal time. If the fuel contains more than 1.0% sulphur, oil change periods should be reduced to one-fourth normal time.
Gravity: Gravity is the measurement of heat units in a certain amount of fuel. The heavier the fuel (the lower the number) the more heat units per volume. If a fuel with a higher A.P.I. gravity is used the power produced will be lower. Select fuels with the lower A.P.I. gravity reading.
Some fuel specifications that meet the above requirements are:
ASTM-D396 - No. 1 & No. 2 fuels (burner fuels)
ASTM-D975 - No. 1D & No. 2D diesel fuel oils
BS2869-Class A1 to Class A2 engine fuels
BS2869-Class C & Class D burner fuels
DIN51601-Diesel fuel
DIN51603- EL heating oil
Authorized dealers are familiar with fuels that have given good results in Caterpillar Diesel Engines and should be consulted regarding fuel use when abnormal conditions occur.