Flywheel
Usage:
(1) Flywheel shoulder.
(2) Install ring gear so that Part No. is on this side. Ring gear must be assembled against shoulder of flywheel.
NOTE: Do not heat ring gear to more than 400°F (204°C) before installing on flywheel.
(3) Pilot bore.
(4) Torque for bolts holding flywheel to crankshaft ... 55 ± 5 lb.ft.(75 ± 7 N·m)
Put 5P3413 Sealant on the bolt threads.
NOTE: Dash mark on flywheel must be in alignment with dash mark on crankshaft.
Caterpillar Information System:
3208 INDUSTRIAL ENGINE Pulley And Damper
3208 INDUSTRIAL ENGINE Flywheel Housing Bore
3208 INDUSTRIAL ENGINE Flywheel Housing Runout
3208 INDUSTRIAL ENGINE Flywheel Runout
3208 INDUSTRIAL ENGINE Bearings For Connecting Rods And Mains
3208 INDUSTRIAL ENGINE Crankshaft
3208 INDUSTRIAL ENGINE Pistons And Rings
3208 INDUSTRIAL ENGINE Connecting Rod
3208 INDUSTRIAL ENGINE Cylinder Block
3208 INDUSTRIAL ENGINE V-Belt Tension Chart
3208 INDUSTRIAL ENGINE Water Temperature Regulator (9N5121)
3208 INDUSTRIAL ENGINE Water Pump
3208 INDUSTRIAL ENGINE Alternators And Regulators
3208 INDUSTRIAL ENGINE Alternator Regulators
3208 INDUSTRIAL ENGINE Starter Solenoids
3208 INDUSTRIAL ENGINE Starter Motors
3208 INDUSTRIAL ENGINE Shutoff Solenoid
3208 INDUSTRIAL ENGINE Systems Operation
3208 INDUSTRIAL ENGINE Testing And Adjusting
3208 INDUSTRIAL ENGINE Introduction
3208 INDUSTRIAL ENGINE Water Temperature Switch 2N2920 Switch
3208 INDUSTRIAL ENGINE Gauge For Water Temperature 5L7446 Gauge; Use with 2N1311 Sending Unit.
3208 INDUSTRIAL ENGINE Sending Unit For Water Temperature 2N1311 Sending Unit; Use with 5L7446 Gauge.
3208 INDUSTRIAL ENGINE Gauge For Engine Oil Pressure 2N781 Gauge; Use with 2N782 Sending Unit.