Flywheel Housing Runout
Usage:
Face Runout (axial eccentricity) of the Flywheel Housing:
8S2328 DIAL INDICATOR GROUP INSTALLED
1. Fasten a dial indicator to the crankshaft flange so the anvil of the indicator will touch the face of the flywheel housing.
2. Put a force on the crankshaft toward the rear before reading the indicator at each point.
A (BOTTOM)
3. With the dial indicator set at .000 in. (0.0 mm) at location (A), turn the crankshaft and read the indicator at locations (B), (C) and (D).
4. The difference between lower and higher measurements taken at all four points must not be more than .010 in. (0.25 mm), which is the maximum permissible face runout (axial eccentricity) of the flywheel housing.
Caterpillar Information System:
3208 INDUSTRIAL ENGINE Flywheel Runout
3208 INDUSTRIAL ENGINE Bearings For Connecting Rods And Mains
3208 INDUSTRIAL ENGINE Crankshaft
3208 INDUSTRIAL ENGINE Pistons And Rings
3208 INDUSTRIAL ENGINE Connecting Rod
3208 INDUSTRIAL ENGINE Cylinder Block
3208 INDUSTRIAL ENGINE V-Belt Tension Chart
3208 INDUSTRIAL ENGINE Water Temperature Regulator (9N5121)
3208 INDUSTRIAL ENGINE Water Pump
3208 INDUSTRIAL ENGINE Oil Level Gauge
3208 INDUSTRIAL ENGINE Oil Pan
3208 INDUSTRIAL ENGINE Oil Pan
3208 INDUSTRIAL ENGINE Flywheel Housing Bore
3208 INDUSTRIAL ENGINE Pulley And Damper
3208 INDUSTRIAL ENGINE Flywheel
3208 INDUSTRIAL ENGINE Alternators And Regulators
3208 INDUSTRIAL ENGINE Alternator Regulators
3208 INDUSTRIAL ENGINE Starter Solenoids
3208 INDUSTRIAL ENGINE Starter Motors
3208 INDUSTRIAL ENGINE Shutoff Solenoid
3208 INDUSTRIAL ENGINE Systems Operation
3208 INDUSTRIAL ENGINE Testing And Adjusting
3208 INDUSTRIAL ENGINE Introduction
3208 INDUSTRIAL ENGINE Water Temperature Switch 2N2920 Switch