Pulley And Damper
Usage:
Install the damper assembly on the crankshaft until the hub of the damper assembly comes in contact with the gear on the crankshaft. DO NOT use the bolt and washer that holds the damper assembly on the crankshaft to install the damper assembly.
(1) Torque for bolt that holds the pulley ... 460 ± 60 lb. ft.(624 ± 80 N·m)
When a front power takeoff is used, increase torque for bolt to ... 700 ± 37 lb. ft.(950 ± 50 N·m)
(2) Distance from end of damper assembly to edge of dust shield ... 1.25 ± .06 in.(31.8 ± 1.5 mm)
(3) When front power takeoff is used, tighten bolts to ... 40 ± 5 lb. ft.(55 ± 7 N·m)
Caterpillar Information System:
3208 INDUSTRIAL ENGINE Flywheel Housing Bore
3208 INDUSTRIAL ENGINE Flywheel Housing Runout
3208 INDUSTRIAL ENGINE Flywheel Runout
3208 INDUSTRIAL ENGINE Bearings For Connecting Rods And Mains
3208 INDUSTRIAL ENGINE Crankshaft
3208 INDUSTRIAL ENGINE Pistons And Rings
3208 INDUSTRIAL ENGINE Connecting Rod
3208 INDUSTRIAL ENGINE Cylinder Block
3208 INDUSTRIAL ENGINE V-Belt Tension Chart
3208 INDUSTRIAL ENGINE Water Temperature Regulator (9N5121)
3208 INDUSTRIAL ENGINE Water Pump
3208 INDUSTRIAL ENGINE Oil Level Gauge
3208 INDUSTRIAL ENGINE Flywheel
3208 INDUSTRIAL ENGINE Alternators And Regulators
3208 INDUSTRIAL ENGINE Alternator Regulators
3208 INDUSTRIAL ENGINE Starter Solenoids
3208 INDUSTRIAL ENGINE Starter Motors
3208 INDUSTRIAL ENGINE Shutoff Solenoid
3208 INDUSTRIAL ENGINE Systems Operation
3208 INDUSTRIAL ENGINE Testing And Adjusting
3208 INDUSTRIAL ENGINE Introduction
3208 INDUSTRIAL ENGINE Water Temperature Switch 2N2920 Switch
3208 INDUSTRIAL ENGINE Gauge For Water Temperature 5L7446 Gauge; Use with 2N1311 Sending Unit.
3208 INDUSTRIAL ENGINE Sending Unit For Water Temperature 2N1311 Sending Unit; Use with 5L7446 Gauge.