Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 185-3630 | Strap Wrench As | 1 |
Personal injury or death can result from a fire. Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. Clean up all leaked or spilled fuel. Do not smoke while working on the fuel system. Turn the disconnect switch OFF or disconnect the battery when changing fuel filters. |
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
- Turn the fuel supply to the “OFF” position.
Show/hide table
Illustration 1 g06318125 - Disconnect fuel pressure sensor harness (1).
Show/hide table
Illustration 2 g06318128 - Remove fuel pressure sensor group (2).
Show/hide table
Illustration 3 g06318142 - Use Tooling (A) to remove fuel filter (3) from fuel filter base.
Show/hide table
Illustration 4 g06318144 - Disconnect hose assemblies (4) an (5).
Show/hide table
Illustration 5 g06318147 - Remove bolts (6). Remove fuel filter base (7).
- Position fuel filter base (7) on the engine. Install bolts (7).
Show/hide table
Illustration 7 g06318144 - Connect hose assemblies (4) and (5).
Show/hide table
Illustration 8 g06318142 - Use Tooling (A) to install the fuel filter (3).
Show/hide table
Illustration 9 g06318128 - Install the fuel pressure sensor on the fuel filter base and tighten to a torque of
10 ± 2 N·m (89 ± 18 lb in) .Show/hide tableIllustration 10 g06318125 - Connect harness assembly (1) for the fuel pressure sensor.
- Turn the fuel supply to the ON position.
- Remove the air from the system. Refer to Testing and Adjusting, Fuel System - Prime.
Illustration 6 | g06318147 |