Engine Oil Lines
Show/hide table
Illustration 1 | g01093847 |
(1) Engine oil line
(2) Washers
Note: The washers must be replaced with new washers when the engine oil line is removed.
(3) Tighten the banjo bolts to the following torque. ...
Caterpillar Information System:
C0.5 and C0.7 Industrial Engines Exhaust Manifold
C0.5 and C0.7 Industrial Engines Flywheel Housing
C0.5 and C0.7 Industrial Engines Piston and Rings
745 and 740 GC & 740 EJECTOR Articulated Truck Systems Electronic Control Module
C0.5 and C0.7 Industrial Engines Connecting Rod
C0.5 and C0.7 Industrial Engines Camshaft
G3516 TA Engine Oxygen Level - Test
Installation Procedure For Mobile Exhaust Port Kit On All Select Caterpillar and Non-Caterpillar Diesel Engines {0781, 1408, 1919, 7466} Installation Procedure For Mobile Exhaust Port Kit On All Select Caterpillar and Non-Caterpillar Diesel Engines {0781, 1408, 1919, 7466}
Marine Selective Catalytic Reduction (SCR) Retrofit Aftertreatment Glossary
3500E Marine Engines Magnetic Switch
3500E Marine Engines Switches
New Turbocharger Troubleshooting for Certain C7 and C9 Truck Engines {0374, 1052, 107F} New Turbocharger Troubleshooting for Certain C7 and C9 Truck Engines {0374, 1052, 107F}
C0.5 and C0.7 Industrial Engines Speed Sensor - If equipped
C0.5 and C0.7 Industrial Engines Atmospheric Pressure Sensor - If equipped
C0.5 and C0.7 Industrial Engines Governor Control - Actuator
789D, 793F, and 797F Off-Highway Truck Monitoring System General Information
3516B Generator Set Engines with Dynamic Gas Blending Restriction of Air Inlet and Exhaust
789D, 793F, and 797F Off-Highway Truck Monitoring System Menus (Advisor)
G3516 Petroleum Engines Aftercooler - Remove and Install
SCR Retrofit Aftertreatment Diesel Particulate Filter - Clean/Inspect
C0.5 and C0.7 Industrial Engines Cooling System
C0.5 and C0.7 Industrial Engines Basic Engine
C0.5 and C0.7 Industrial Engines Electrical System
C0.5 and C0.7 Industrial Engines Engine Valve Lash - Inspect/Adjust