Water Temperature Regulator - Remove and Install
- Drain the coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.
Show/hide table
Illustration 1 g06108786 - Loosen hose clamp (2) and disconnect hose (1).
- Remove bolts (3), bolt (5), and water temperature regulator assembly (4).
- Install water temperature regulator assembly (4).
Caterpillar Information System:
PM820, PM822, and PM825 Cold Planer Machine Systems Hydraulic Cylinder (Conveyor Swing) - Remove and Install
C175 Tier 4 Final Engines for Off-Highway Trucks Event Codes
C175 Tier 4 Final Engines for Off-Highway Trucks Diagnostic Trouble Codes
PM820, PM822, and PM825 Cold Planer Machine Systems Hydraulic Cylinder (Rear Steering) - Remove and Install
C175 Tier 4 Final Engines for Off-Highway Trucks Solenoid Valve - Test - Engine
C175 Tier 4 Final Engines for Off-Highway Trucks Solenoid Valve - Test - Aftertreatment
C2.4 Tier 4 Final Engines for Caterpillar Built Machines Exhaust Has Excessive White Smoke
Fuel Line Serviceability for Certain Tier 4 C175 Engines {1100, 1101, 1252} Fuel Line Serviceability for Certain Tier 4 C175 Engines {1100, 1101, 1252}
C2.4 Tier 4 Final Engines for Caterpillar Built Machines Exhaust Temperature Is High
PM820, PM822, and PM825 Cold Planer Machine Systems Hydraulic Cylinder (Front Steering) - Remove and Install
Relay Compatibility Issue on Continuous Oil Prelube on 3508 Fire Pump Engines {1319} Relay Compatibility Issue on Continuous Oil Prelube on 3508 Fire Pump Engines {1319}
A New Turbine Inlet Bellows is Available for 3512 Locomotive Engines {1059} A New Turbine Inlet Bellows is Available for 3512 Locomotive Engines {1059}
C175-16 Oil and Gas Generator Set Refill Capacities
PM820, PM822, and PM825 Cold Planer Machine Systems Hydraulic Cylinder (Conveyor Lift) - Remove and Install
C175-16 Oil and Gas Generator Set Maintenance Recommendations
C175-16 Oil and Gas Generator Set Marine Classification Society Certification Requirements
C7.1 Marine Engine Rocker Arm and Shaft - Remove
C7.1 Marine Engine Rocker Arm and Shaft - Install
G3512 Generator Set Maintenance Interval Schedule - Standby
G3512 Generator Set Maintenance Interval Schedule - Load Management/Continuous
C7.1 Marine Engine Camshaft - Remove
C7.1 Marine Engine Camshaft - Install
New Engine Software on Certain C4.4 Generator Sets {1901, 1920} New Engine Software on Certain C4.4 Generator Sets {1901, 1920}
G3512 Generator Set Speed Sensor - Clean/Inspect