Configuration Parameters
Some system configuration parameters can be configured by the customer to suit the customer particular application. The configuration file contains all the adjustable settings for the monitoring system. The engine is shipped from the factory with default values for these parameters. configuration parameters must be reprogrammed if an ECM is replaced and/or the engine rating is reprogrammed. if the flash file is replaced, configuration parameters will not require reprogramming. Proper values for these parameters are available on Cat Electronic Technician (ET). Certain configuration parameters are also stamped on the engine information plate.
If the default settings for the parameters have been modified, there will be no record at the factory of the changes. These settings can be downloaded into a laptop computer and saved to a file. The customer can then use the file to facilitate replacement of the ECM.
Note: Changing the parameters that are protected by factory passwords may cause your Cat warranty to be voided.
Note: For information on configuration parameters refer to the Troubleshooting Manual, UENR2994.
Caterpillar Information System:
C175-20 Locomotive Engine Refill Capacities
Cat Gas Engine Lubricant, Fuel, and Coolant Recommendations Hydraulic Oil
Cat Gas Engine Lubricant, Fuel, and Coolant Recommendations Coolant Recommendations
C175-16 and C175-20 Generator Set Engines Fuel Pressure Is Low
Open Crankcase Ventilation System May Experience Freezing on Certain C13, C15, and C18 Generator Set Engines {107F} Open Crankcase Ventilation System May Experience Freezing on Certain C13, C15, and C18 Generator Set Engines {107F}
C175-20 Locomotive Engine Maintenance Interval Schedule
Technical Analysis 1 (TA1) Visual Inspection for Industrial Engine {0372, 1000, 7000, 753S, 7565} Technical Analysis 1 (TA1) Visual Inspection for Industrial Engine {0372, 1000, 7000, 753S, 7565}
A New Fuel Injection Pump Group is Used on Certain C9.3 Commercial Engines {1251} A New Fuel Injection Pump Group is Used on Certain C9.3 Commercial Engines {1251}
C175–16 Locomotive Engine Fuel Injector
Cat Gas Engine Lubricant, Fuel, and Coolant Recommendations General Lubricant Information
C175–16 Locomotive Engine Fuel Injector
C175–16 Locomotive Engine Valve Mechanism - Hydraulic Lash Adjusters
C175-20 Locomotive Engine Overhaul Considerations
C175-20 Locomotive Engine Overhaul (Intermediate)
C18 Generator Set Engines Relay (ARD Nozzle Heater) - Remove and Install
Exhaust Gas Valve (NRS) for C7.1, C6.6, andC4.4 Engines {1050, 108N} Exhaust Gas Valve (NRS) for C7.1, C6.6, andC4.4 Engines {1050, 108N}
C175-20 Locomotive Engine Overhaul (Major)
PM620, PM622, PM820, PM822 and PM825 Cold Planers Electronic System Sensor Signal (Analog, Active) - Test
C175-20 Locomotive Engine Nitrogen Oxide Sensor - Replace
XQ570 Rental Generator Set Voltage Regulators
XQ570 Rental Generator Set Electronic Modular Control Panel 4 (EMCP 4)
A New Sea Water Pump Is Used on Certain 3608 Marine Auxiliary Engines {1371} A New Sea Water Pump Is Used on Certain 3608 Marine Auxiliary Engines {1371}
G3512 Generator Set Engines Throttle Actuator - Test
C18 Generator Set Engines Diesel Exhaust Fluid Module - Disassemble