Refill Capacities
The capacity of the engine lubrication system includes the capacity of the oil filters that are installed at the factory. Auxiliary oil filter systems (if equipped) will require more oil. Refer to the specifications that are provided by the OEM of the auxiliary oil filter system.
Show/hide table
C175-20 Engine Oil Refill Capacities | |
With oil filter change | |
Without oil filter change | |
Factory fill | |
Volume between "ADD" and "Full" marks on the engine oil level gauge (dipstick). | |
To maintain the cooling system, the total cooling system capacity must be determined. The total cooling system capacity will vary between individual installations. The total cooling system capacity can include the following components (if equipped): engine, expansion tank, heat exchanger, radiator, piping, and other cooling system parts.
Cooling system capacities will be determined by the OEM of the installation. Record total cooling system capacities.
Caterpillar Information System:
Cat Gas Engine Lubricant, Fuel, and Coolant Recommendations Hydraulic Oil
Cat Gas Engine Lubricant, Fuel, and Coolant Recommendations Coolant Recommendations
C175-16 and C175-20 Generator Set Engines Fuel Pressure Is Low
Open Crankcase Ventilation System May Experience Freezing on Certain C13, C15, and C18 Generator Set Engines {107F} Open Crankcase Ventilation System May Experience Freezing on Certain C13, C15, and C18 Generator Set Engines {107F}
C175-20 Locomotive Engine Maintenance Interval Schedule
Technical Analysis 1 (TA1) Visual Inspection for Industrial Engine {0372, 1000, 7000, 753S, 7565} Technical Analysis 1 (TA1) Visual Inspection for Industrial Engine {0372, 1000, 7000, 753S, 7565}
A New Fuel Injection Pump Group is Used on Certain C9.3 Commercial Engines {1251} A New Fuel Injection Pump Group is Used on Certain C9.3 Commercial Engines {1251}
C175–16 Locomotive Engine Fuel Injector
Cat Gas Engine Lubricant, Fuel, and Coolant Recommendations General Lubricant Information
C175–16 Locomotive Engine Fuel Injector
C175–16 Locomotive Engine Valve Mechanism - Hydraulic Lash Adjusters
XQ35 Rental Generator Set Sensors and Electrical Components - Engine and Aftertreatment
C175-16 Locomotive Engine Configuration Parameters
C175-20 Locomotive Engine Overhaul Considerations
C175-20 Locomotive Engine Overhaul (Intermediate)
C18 Generator Set Engines Relay (ARD Nozzle Heater) - Remove and Install
Exhaust Gas Valve (NRS) for C7.1, C6.6, andC4.4 Engines {1050, 108N} Exhaust Gas Valve (NRS) for C7.1, C6.6, andC4.4 Engines {1050, 108N}
C175-20 Locomotive Engine Overhaul (Major)
PM620, PM622, PM820, PM822 and PM825 Cold Planers Electronic System Sensor Signal (Analog, Active) - Test
C175-20 Locomotive Engine Nitrogen Oxide Sensor - Replace
XQ570 Rental Generator Set Voltage Regulators
XQ570 Rental Generator Set Electronic Modular Control Panel 4 (EMCP 4)
A New Sea Water Pump Is Used on Certain 3608 Marine Auxiliary Engines {1371} A New Sea Water Pump Is Used on Certain 3608 Marine Auxiliary Engines {1371}
G3512 Generator Set Engines Throttle Actuator - Test