Fuel Priming Pump - Remove and Install
- Turn OFF the fuel supply to the engine.
Show/hide table
Illustration 1 g01289977 - Disconnect tube assemblies (1) and (2) from fuel priming pump (4). Place protective covers on all of the openings.
- Remove the bolts that hold fuel priming pump (4) to the bracket. Remove fuel priming pump (4).
- Remove check valve (3) from fuel priming pump (4).
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install fuel priming pump (4) in the reverse order of removal.
- Ensure check valve (3) is installed in the correct orientation.
Caterpillar Information System:
3512E Tier 4 Final Engines for Land Electric Drilling Sensor Signal (Analog, Passive) - Test
3512E Tier 4 Final Engines for Land Electric Drilling Coolant Level Is Low
3512E Tier 4 Final Engines for Land Electric Drilling Speed Control - Test
3512, 3508 and 3516 Generator Sets Maintenance Interval Schedule - Standby
Installation Procedure to Retrofit Overhead Guard and Front Window Guard Upgrade Kits on the Cab of Certain Large Excavators and Mobile Hydraulic Power Units {7159} Installation Procedure to Retrofit Overhead Guard and Front Window Guard Upgrade Kits on the Cab of Certain Large Excavators and Mobile Hydraulic Power Units {7159}
3512, 3508 and 3516 Generator Sets Maintenance Interval Schedule - Prime Power
Installation Procedure for the Jacket Water Bypass Tube Bracket on Certain 3512C Engines{1380} Installation Procedure for the Jacket Water Bypass Tube Bracket on Certain 3512C Engines{1380}
C280-16 Tier 4 Marine Engine and C280-12 Tier 4 Marine Engine Turbocharger - Remove and Install
C13 Industrial Engine Intake Manifold Air Pressure Is Low
C175-16 Locomotive Engine Turbocharger Turbine Temperature Is High
2014/11/21 A New Jacket Water Bypass Bracket Is Used on Certain 3512C Engines {1380}
C13 Industrial Engine Fuel Pressure Is Low
3512E Tier 4 Final Engines for Land Electric Drilling Sensor Signal (Analog, Active) - Test
C4.4 Engines General Information
Installation Procedure to Retrofit a 471-1985 Swivel Guard Upgrade Kit on Certain Excavators {7153} Installation Procedure to Retrofit a 471-1985 Swivel Guard Upgrade Kit on Certain Excavators {7153}
3500 Generator Sets Maintenance Interval Schedule - Standby
2014/11/14 New EMCP 3.2/3.3 Software Is Now Available For Use On Certain Cat® Products {4490, 7620}
793F Off-Highway Truck Fuel Correction Factor - Set
3500 Generator Sets Maintenance Interval Schedule - Prime Power
3500 Generator Sets Maintenance Interval Schedule - High Displacement
C13 Industrial Engine Exhaust System Contains Oil
C13 Industrial Engine Exhaust Temperature Is High
C13 Industrial Engine Fuel Consumption Is Excessive
C13 Industrial Engine Fuel Pressure Is High