Assembly Procedure
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
A     | 347-9017     | Cat Multipurpose Marine Grease     | 1     |
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.
Note: Check the O-ring seals for wear or for damage. Replace the components, if necessary.
Note: Lubricate O-rings and seals with lubricant used while in operation.
- Install O-rings (19) .
Illustration 1 | g03391572 |
- Install Teflon seal (18) from each end of ring gear.
Illustration 2 | g03391561 |
- Apply Tool (A) to ring gear assembly.
- Install ring gear (17). Install three bolts (16) .
- Install ring gear assembly in gear box housing (1) .
- Install one stop bolt (15) on each side of gear box housing (1) .
Note: The stops limit the direction of rotation. Before the water cannon is operated, confirm that the stops are installed correctly.
Note: Steel stops have a double hex head. Plastic plugs have a single hex head. Plastic plugs do not act as stops.
Illustration 3 | g03391560 |
Illustration 4 | g03391571 |
- Fasten four bolts (14) to the rotating side of gear box housing (1) .
Illustration 5 | g03391559 |
Note: The UP/DOWN gear box housing and the RIGHT/LEFT gear box housing are installed in the same manner.
Note: The rotating base tube is connected to the UP/DOWN gear box housing. The rotating nozzle tube is connected to the RIGHT/LEFT gear box housing. The two gear box housings are connected with a non-rotating tube (3) .
- Install worm drive gear (13) into gear box housing (1) .
Note: Rotate worm drive gear (13) in order to install the gear in ring gear (17). Hold the mounting plate securely while the worm gear shaft is rotated.
Illustration 6 | g03391553 |
- Fasten four bolts (12) .
- Install motor seal (10) .
Illustration 7 | g03391552 |
- Position adapter on motor (7).
Illustration 8 | g03391529 |
- Fasten five bolts (9). Install O-ring (8) .
- Install motor (7) on gear box housing (1). Fasten four bolts (6) .
Illustration 9 | g03391528 |
- Install O-ring (4) and O-ring (5) .
Illustration 10 | g03391527 |
- Position non-rotating tube (3) to gear box housing (1) .
Illustration 11 | g03391526 |
- Fasten four bolts (2) to attach non-rotating tube (3) to gear box housing (1) .
Note: Use a suitable lifting device to move water cannon (1). The water cannon weighs approximately 26.7 kg (58.9 lb).
End By: Install the water cannon.