Exhaust Gas Valve (NRS) - Assemble
Assembly Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | -     | Loctite C5A Copper Anti-Seize     | -     |
B     | 1P-0808     | Multipurpose Grease     | -     |
- Lubricate all of the O-ring seals with the lubricant that is being sealed.
Show/hide table
Illustration 1 | g01896079 |
- Install O-ring seals (9) and (10) onto spool (5) .
- Install spool (5) into the actuator housing. Tighten spool (5) to a torque of 50 ± 5 N·m (37 ± 4 lb ft).
Show/hide table
Illustration 2 | g01845473 |
- Install solenoid (6), washer (7), and nut (8) .
- Tighten nut (8) to a torque of 20 ± 2.5 N·m (177 ± 22 lb in).
- Fill Cavity (B) to the halfway mark with Tooling (B). Cavity (B) is found on the valve housing.
Show/hide table
Illustration 3 | g01871983 |
- Position actuator assembly (3) on valve housing (4). Install bolts (2) .
Show/hide table
Illustration 4 | g01845346 |
- Apply Tooling (A) to the threads on temperature sensor (1). Install temperature sensor (1). Tighten temperature sensor (1) to a torque of 45 ± 5 N·m (33 ± 4 lb ft).
End By: Install the exhaust gas valve (NRS).
Caterpillar Information System:
C18 Locomotive Engine Exhaust Gas Valve (NRS) - Disassemble
C18 Locomotive Engine Exhaust Gas Valve (NRS) - Remove and Install
C175-16 Locomotive Engine Fuel System Operation
3516C HD Petroleum Well Service Engines Hydraulic Starting System
3516C HD Petroleum Well Service Engines Jacket Water Cooling Circuit
3516C HD Petroleum Well Service Engines Camshaft
C280-16 Engine Refill Capacities
C7.1 Marine Engine Fuel Priming Pump - Remove and Install
C280-16 Engine Product Description
C4.4 (Mech) Marine Generator Set MCS-3 Engine Crankcase Breather - Replace - Turbocharged Engines
C7.1 Engines for Caterpillar Built Machines Fuel Injection Timing - Check
C4.4 (Mech) Marine Generator Set MCS-3 Severe Service Application
C175-16 Locomotive Engine Air Inlet and Exhaust System Operation
C18 Locomotive Engine Exhaust Manifold - Remove and Install - For Series Turbocharger Applications
2013/02/18 A New Compressor Outlet Bracket Is Used for Certain G3512E Engines {1071}
C280-16 Engine Air Shutoff - Test
2014/04/15 An Improved Lip Type Seal and Wear Sleeve Seal Are Now Used in the Transfer Gear Group of Certain 777 Off-Highway Trucks {3159}
C280-16 Engine Aftercooler Condensation - Drain
C280-16 Engine Engine Oil - Change
C280-16 Engine Engine Oil Filter - Change
C280-16 Engine Engine Oil Temperature Regulator - Replace
C18 Locomotive Engine Exhaust Cooler (NRS) - Remove and Install - For Series Turbocharger Applications
C280-16 Engine Coolant - Change
C32 Marine Engines Piston and Rings