NOTICE |
---|
Refer to Systems Operation, Testing, and Adjusting, "Cleanliness of Fuel System Components" for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system. |
If necessary, install a new fuel filter element to canister (2). Refer to Operation and Maintenance Manual, "Fuel System Primary Filter (Water Separator) Element - Replace" for the correct procedure.
Illustration 1 | g02606186 |
Typical example |
(1) Tighten the water in fuel sensor to the following torque. ...
Note: Tighten water in fuel sensor until the O-ring seal comes into contact with the bowl of the water separator. Tighten the water in fuel sensor an additional 180 degrees.
(3) Tighten the connection to the following torque. ...
(4) Tighten the setscrews to the following torque. ...