Turbocharger - Remove
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates. |
Note: Plug and cap all open ports and tube assemblies.
- The engine can have the ability to auto start. Ensure that the power supply is isolated before any service or repairs is performed.
- Loosen the band clamps and disconnect the exhaust elbow from the turbocharger.
- Loosen the hose clamps and remove the air inlet hose from the turbocharger.
- Loosen the hose clamp and release the air outlet hose from the turbocharger.
- Remove the blanket from the turbocharger.
Show/hide table
Illustration 1 g01608830 - Follow Steps 6.a through 6.c in order to remove tube assembly (3) for the oil feed.
- Remove bolt (7).
- Remove banjo bolt (1) and remove sealing washers (2).
- Remove tube assembly (3) from the cylinder block. Remove O-ring seal (5) from the tube assembly.
Note: Plug the port for the oil feed to the turbocharger with a suitable plug.
- Follow Steps 7.a through 7.c in order to remove tube assembly (9) for the oil drain.
- Remove bolts (11).
- Remove bolts (8) and remove tube assembly (9) from turbocharger (4).
Note: Plug the port for the tube assembly to the turbocharger with a suitable plug.
- Remove gasket (6) and remove gasket (10).
Show/hide tableIllustration 2 g01608835 - Remove nuts (12) from turbocharger (6) and remove turbocharger (6) from exhaust manifold (13).
- Remove gasket (14).
- If necessary, remove studs (15) from exhaust manifold (13).
Caterpillar Information System:
C6.6 Marine Generator Set Air Cleaner Housing - Remove and Install
C6.6 Marine Generator Set Electronic Unit Injector - Install
C6.6 Marine Generator Set Electronic Unit Injector - Remove
C6.6 Marine Generator Set Fuel Injection Pump Gear - Install
C6.6 Marine Generator Set Fuel Injection Pump Gear - Remove
C6.6 Marine Generator Set Fuel Injection Pump - Install
C6.6 Marine Generator Set Fuel Injection Pump - Remove
C6.6 Marine Generator Set Fuel Injection Lines - Install - Twin Wall Fuel Injection Lines
C6.6 Marine Generator Set Fuel Injection Lines - Remove - Twin Wall Fuel Injection Lines
C6.6 Marine Generator Set Fuel Manifold (Rail) - Remove and Install
C6.6 Marine Generator Set Fuel Transfer Pump - Install
C6.6 Marine Generator Set Fuel Transfer Pump - Remove
C6.6 Marine Generator Set Turbocharger - Install
C6.6 Marine Generator Set Exhaust Manifold - Remove and Install
C6.6 Marine Generator Set Inlet Manifold - Remove and Install
C6.6 Marine Generator Set Inlet and Exhaust Valve Springs - Remove and Install
C6.6 Marine Generator Set Inlet and Exhaust Valves - Remove and Install
C6.6 Marine Generator Set Engine Oil Filter Base - Remove and Install
C6.6 Marine Generator Set Engine Oil Cooler - Remove
C6.6 Marine Generator Set Engine Oil Cooler - Install
C6.6 Marine Generator Set Engine Oil Relief Valve - Remove and Install
C6.6 Marine Generator Set Engine Oil Pump - Remove
C6.6 Marine Generator Set Engine Oil Pump - Install
C6.6 Marine Generator Set Water Pump - Remove