Housing (Front) - Remove
Start By:
- Remove the fan drive, if necessary. Refer to Disassembly and Assembly, "Fan Drive - Remove".
- Remove the fuel filter base. Refer to Disassembly and Assembly, "Fuel Filter Base - Remove and Install ".
- Remove the unit injector hydraulic pump. Refer to Disassembly and Assembly, "Unit Injector Hydraulic Pump - Remove".
- Remove the auxiliary water pump, if necessary. Refer to Disassembly and Assembly, "Auxiliary Water Pump - Remove".
- Remove the air compressor, if necessary. Refer to Disassembly and Assembly, "Air Compressor - Remove and Install".
- Remove the crankshaft front seal. Refer to Disassembly and Assembly, "Crankshaft Front Seal - Remove".
- Remove the camshaft. Refer to Disassembly and Assembly, "Camshaft - Remove".
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Disconnect harness assemblies (1) and (2).
Show/hide table
Illustration 2 g01151892 - Remove bolts (5).
- Remove bolts (3).
- Remove front housing (4).
Show/hide table
| |
| Illustration 1 | g01151885 |
Caterpillar Information System:
2007/12/03 Improved PL1000T Hardware and Software is Now Available {7610}
C3.3 Industrial Engine Model View Illustrations
C4.4 Generator Set Engines Injector Data Incorrect - Test
G3520B Industrial Engines Diagnostic Trouble Codes
G3520B Industrial Engines Event Codes
3176C, 3406E and 3456 Industrial Engines ECM Does Not Communicate with Other Modules
3516B Engine for 994F and 994H Wheel Loaders Coolant Contains Oil
2007/11/26 Improved PL1000E Hardware and Software is Now Available {7610}
C9 Petroleum Engines Gear Group (Front) - Install
C9 Petroleum Engines Gear Group (Front) - Remove
Electronic Modular Control Panel II+ Paralleling (EMCP II+P) Parallel Setpoint Viewing OP2-3
C27 and C32 Engines for Caterpillar Built Machines Valve Actuator (Variable) - Remove
TH55-E70 and TH55-E90 Petroleum Transmissions Transmission and Torque Converter - Separate
TH55-E70 and TH55-E90 Petroleum Transmissions Transmission and Torque Converter - Connect
C15 and C18 Petroleum Generator Sets Speed Sensor - Clean/Inspect
C9 Petroleum Engines Housing (Front) - Install
TH55-E70 and TH55-E90 Petroleum Transmissions Torque Converter - Remove
TH55-E70 and TH55-E90 Petroleum Transmissions Torque Converter - Install
TH55-E70 and TH55-E90 Petroleum Transmissions Torque Converter - Disassemble
TH55-E70 and TH55-E90 Petroleum Transmissions Torque Converter - Assemble
C4.4 Generator Set Engines Injector Solenoid Circuit - Test
C27 and C32 Engines for Caterpillar Built Machines Valve Actuator (Variable) - Install
C9 Petroleum Engines Crankcase Breather - Remove and Install
G3600 Engines Sensor Signal (PWM) - Test