Gear Group (Front) - Remove
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 1P-0510 | Driver Gp | 1 |
Start By:
- Remove the front housing. Refer to Disassembly and Assembly, "Housing (Front) - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Set the No. 1 piston to top center on the compression stroke. Refer to Testing and Adjusting, "Finding Top Center Position for No. 1 Piston".
Show/hide table
Illustration 1 g01435071 - Mark the orientation of each of the gears for installation purposes.
- Remove bolts (4), bolt (6), and retaining plate (7).
- Remove idler gear assembly (3), idler shaft (2), and thrust plate (1) from the cylinder block.
- Use Tooling (A) to remove bearing (5) from idler gear assembly (3).
Note: Removal of the engine oil pan may be necessary in order to remove the idler gear assembly for the engine oil pump.
- Remove bolt (8), retaining plate (9), and idler gear assembly (10).
- Check the condition of the bearing in idler gear assembly (10). If the bearing is worn or damaged, replace the idler gear assembly.
Caterpillar Information System:
Electronic Modular Control Panel II+ Paralleling (EMCP II+P) Parallel Setpoint Viewing OP2-3
C27 and C32 Engines for Caterpillar Built Machines Valve Actuator (Variable) - Remove
C18 Petroleum Generator Sets Instrument Panel - Inspect
3176C, 3406E and 3456 Industrial Engines Diagnostic Code Cross Reference
C9 Petroleum Engines Front Cover - Remove and Install
3176C, 3406E and 3456 Industrial Engines Engine Overspeeds
C4.4 Engines for Caterpillar Built Machines Engine Speed/Timing Sensor Circuit - Test
3176C, 3406E and 3456 Industrial Engines Coolant Level - Test
C13, C15, and C18 Tier 4 Final Engines Air Lines
3176C, 3406E and 3456 Industrial Engines Indicator Lamp - Test
3176C, 3406E and 3456 Industrial Engines Electronic Service Tool Does Not Communicate
C9 Petroleum Engines Flywheel Housing - Remove and Install
C9 Petroleum Engines Gear Group (Front) - Install
2007/11/26 Improved PL1000E Hardware and Software is Now Available {7610}
3516B Engine for 994F and 994H Wheel Loaders Coolant Contains Oil
3176C, 3406E and 3456 Industrial Engines ECM Does Not Communicate with Other Modules
G3520B Industrial Engines Event Codes
G3520B Industrial Engines Diagnostic Trouble Codes
C4.4 Generator Set Engines Injector Data Incorrect - Test
C3.3 Industrial Engine Model View Illustrations
2007/12/03 Improved PL1000T Hardware and Software is Now Available {7610}
C9 Petroleum Engines Housing (Front) - Remove
TH55-E70 and TH55-E90 Petroleum Transmissions Transmission and Torque Converter - Separate
TH55-E70 and TH55-E90 Petroleum Transmissions Transmission and Torque Converter - Connect