Circuit Breaker
Description
Show/hide table
Illustration 1 | g01284880 |
(1) Location of the Circuit Breaker "CB1" |
The Circuit Breaker "CB1" is located on the lower left panel next to the fan fuses in the cabinet for the flywheel. The Circuit Breaker (1) allows the operator to disconnect the 480 VAC power that is coming from the UPS.
The breaker (1) is supplied 380 VAC to 480 VAC power from the control power in the control cabinet. The breaker (1) is rated at 10 amp.
Show/hide table
Illustration 2 | g01284885 |
Wire Connections for the Circuit Breaker |
Removal Procedure
Refer to Systems Operation, Testing and Adjusting, RENR7654, "Internal Component Preremoval Steps (Flywheel Cabinet)" in order to shut down the system and gain access to internal components.
- Disconnect the wires from the circuit breaker (1). Refer to Illustration 2.
- Remove the two screws that hold the rail stop to the rail.
- Remove the rail stop that is located on the side of the circuit breaker (1) .
- Remove the circuit breaker (1) by sliding the circuit breaker (1) off the rail.
Installation Procedure
- Connect the circuit breaker (1) to the rail on the lower left panel of the cabinet. Place the top side of the circuit breaker (1) over the top side of the rail and then snap the bottom side of the circuit breaker onto the rail. Refer to Illustration 2.
- Connect the wires to the circuit breaker. Refer to Illustration 2.
- Install the rail stop. Slide the rail stop over the rail and install the two screws.
Caterpillar Information System:
3512C Engine for Caterpillar Built Machines System Overview
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Flywheel Transformer (T1)
3500B Industrial Engine Before Starting Engine
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Flywheel Precharge Resistors
3512C Engine for Caterpillar Built Machines Event Code List
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Diode Bridge
G3520C and G3520E Generator Set Engines Diagnostic Trouble Codes
3512C Engine for Caterpillar Built Machines Diagnostic Code List
3500 Generator Sets Overhaul Considerations
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Flywheel Precharge Contactor (K1, K2)
3500B Industrial Engine Speed Sensor - Clean/Inspect
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Vacuum Pump Oil - Change
G3500 A3 Engines Turbocharger
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys DC Bus Disconnect Switch
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Hall Current Transformer
G3500 A3 Engines Turbocharger
G3500 A3 Engines Exhaust Manifold - Water cooled
C15 Petroleum Generator Set Engines Valve Mechanism
C175-16 Locomotive Engine Cold Mode Operation
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys DC Bus Interface PWA
Mechanical Application and Installation Guide for the CX35 On-Highway Transmission{1400, 1408, 3030, 3101} Mechanical Application and Installation Guide for the CX35 On-Highway Transmission{1400, 1408, 3030, 3101}
3500 Industrial Engines Exhaust Flange
3500 Industrial Engines Exhaust Flange
3612 and 3616 Engines Air Starting Motor - Assemble